Denon AVR-X510BT Owner's Manual download pdf (Page 79)

Input Select

Set the audio input mode and decode mode of each input source.

The input modes available for selection may vary depending on the input

source.

“Input Select” settings are stored for each input source.

Input Mode

Set the audio input modes for the different input sources.

It is normally recommended to set the audio input mode to “Auto”.

Auto

(Default):

Automatically detect input signal and

perform playback.

HDMI: Play only signals from HDMI input.

Digital: Play only signals from digital audio input.

Analog: Play only signals from analog audio input.

When digital signals are properly input, the ~ indicator lights on the display. If

the ~ indicator does not light, check “Input Assign” and the connections.

(v p. 78)

Decode Mode

Set the audio decode mode for input source.

It is normally recommended to set the audio input mode to “Auto”. But

we recommend changing it to “PCM” or “DTS” if the start of the source

is clipped or noise occurs.

Auto

(Default):

Detect type of digital audio input signal

and decode and play automatically.

PCM: Decode and play only PCM input signals.

DTS: Decode and play only DTS input signals.

This item can be set for input sources for which “OPTICAL1” or “OPTICAL2” is

assigned at “Input Assign” (v p. 78).

Contents Connections Playback Settings Tips Appendix

Front panel Display Rear panel Remote Index

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 126 127

No comments

Denon AVR-X510BT Owner's Manual Page 79