Denon AVR-X510BT Owner's Manual download pdf (Page 83)

Connect the Sound calibration microphone to the

SETUP MIC jack of this unit.

When the Sound calibration microphone is

connected, the following screen is displayed.

Auto Setup

Your AVR can automatically measure the

acoustics of your room and the optimize

your speakers.

Start

Select “Start”, then press ENTER.

Select “Next”, then press ENTER.

Select “Begin Test”, then press ENTER.

Measurement requires several minutes.

NOTE

If “Caution!” is displayed on TV screen:

Go to “Error messages” (v p. 84). Check any related items, and

perform the necessary procedures.

To cancel Auto Setup

Press BACK to display the popup screen.

Press o to select “Yes”, then press ENTER.

Unplug the Setup and measurement microphone from

the unit’s SETUP MIC jack.

Do not change the speaker connection or subwoofer volume after

“Auto Setup”. If these are changed, run “Auto Setup” again in order

to configure the optimum equalizer settings.

Contents

Connections Playback Settings Tips Appendix

Front panel Display Rear panel Remote Index

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 126 127

No comments

Denon AVR-X510BT Owner's Manual Page 83