Denon AVR-3300 User Manual download pdf (Page 20)

ENGLISH

ENTER

Enter the setting.

a) If no surround speakers are used (if “None” is set for both A and B):

The System Setup Menu reappears.

b) If both surround speakers A and B are used (if either “Large” or “Small” is set for both A and B):

The surround speaker setting screen appears.

c) If “None” is set for surround speakers A:

“None” is automatically set for surround speakers B.

NOTE:

• Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency

(approximately 80 Hz and below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level low

enough so as not to damage the speakers) to determine the proper setting.

• Parameters

Large…… Select this when using speakers that can fully reproduce low sounds of below 80 Hz.

Small…… Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume.

When this setting is selected, low frequencies of below 80 Hz are assigned to the subwoofer.

None…… Select this when no speakers are installed.

Yes/No…. Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.

If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, center

and surround speakers.

For the majority of speaker system configurations, using the SMALL setting for all five main speakers and Subwooofer On with a connected

subwoofer will yield the best results.

Selecting the surround speakers for the different surround modes

• At this screen preset the surround speakers to be used in the different surround modes.

ENTER

When either “Large” or “Small” has been set for both speakers A and B

on the System Setup Menu (when using both A and B surround speakers),

the surround speaker setting screen appears.

Select the surround speakers to be used in the different surround modes.

• To select the surround mode

• To select the surround speaker

A: When using surround speakers A

B: When using surround speakers B

A+B: When using both surround speakers A and B

Enter the setting.

The System Setup Menu reappears.

Speaker type setting when using both surround speakers A and B

If “Small” is set for either surround speakers A or B, the output is the same as when “Small” is set for both A and B.

Setting the bass output

At the System Setup Menu select “Bass Output”.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 61 62

No comments

Denon AVR-3300 User Manual Page 20