Denon AVR-687 User Manual download pdf (Page 47)

ENGLISH

Advanced Setup – Part 1 Advanced Setup – Part 1

Setting the 2ch Direct/Stereo Custom

Make the 2-channel direct mode and stereo mode speaker settings.

Press

to select “ON”, then press

Large:

Select this when using large speakers with ample low frequency

reproduction capabilities.

Small:

Select this when using small speakers without ample low

frequency reproduction capabilities.

Press

DD HH

to select the item, then press

FF GG

to set.

1 2 A u t o S u r r . O N

5 2 c h C s t m O N

6 2 c h F L a r g e

7 2 c h S W Y e s

8 2 c h L F E N o r m

9 2 c h F L 1 2 f t

1 1 2 c h F r e q 8 0

LFE (Normal):

For any channel(s) that are set to “Large”, low frequencies in that

channel’s corresponding source are directed to that loudspeaker

only. The low frequencies played from the subwoofer are only the

LFE signals and the low frequencies of channels set to “Small”.

LFE+Main:

Low frequencies from speaker channels that have been set to

“Large” are reproduced from those speakers as well as from the

subwoofer(s).

Yes, No:

Select “Yes” when a subwoofer is connected, “No” when no

subwoofer is connected.

Press ENTER or

to enter the setting and switch to

the Auto Surround Mode setting.

5 2 c h C s t m O F F

3 P . O n L A S T

4 M u t e F U L L

2 L i m i t - 1 0 d B

Setting the Volume Control

This sets the volume level of output.

Press

DD HH

to select the item, then press

FF GG

to set.

Volume Limit:

Set the volume’s upper limit.

• 0 dB, –10 dB, –20 dB:

The volume cannot be increased above the selected levels.

• OFF:

If you do not want to set a volume limit, select “OFF”.

In this case, the volume can be set to the AVR-687’s maximum

volume (output) level of +18 dB, which is extremely loud.

Muting Level:

Set the level of volume attenuation in the mute mode.

• FULL:

The volume is fully muted.

• –40 dB, –20 dB:

The volume is lowered 40 dB or 20 dB from the current level.

Power On Volume Level:

• LAST:

The volume set when the AVR-687 was last used is stored in the

memory and set when the power is turned on.

• – – – (Mute):

The volume is always muted when the power is turned on.

• –80 dB ~ +18 dB:

Set the volume level when the power is turned on.

You can adjust the MAIN ZONE volume level within the range of

–80 to +18 dB (and ZONE2 volume level within the range of –70 to

+18 dB).

Press ENTER or

to enter the setting and switch to

the 2ch Direct/Stereo Custom setting.

1 0 2 c h F R 1 2 f t

Crossover Frequency (40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz):

Set as desired according to your speakers’ bass playback ability.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 63 64

Comments to this Manuals

No comments

Denon AVR-687 User Manual Page 47

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-687