Denon AVR-687 User Manual download pdf (Page 48)

ENGLISH

Advanced Setup – Part 1

Advanced Setup – Part 2

• If the “Auto Setup” procedure has already been performed, there is

no need to make this setting.

• Perform this setting if you wish to make the settings for your

speaker systems manually.

Speaker Setup

Press ENTER or

to enter the setting and switch to

the Subwoofer Mode Setup setting.

Setting the Speaker Configuration

Automatically set the output component and properties for the

various channels according to the combination of speakers to be

actually used for surround playback.

Press

FF GG

to select “1. Sp”, then press ENTER.

Press

DD HH

to select the speaker, then press

FF GG

to set.

Large:

Select this when using large speakers with ample low frequency

reproduction capabilities.

Small:

Select this when using small speakers without ample low frequency

reproduction capabilities.

Yes / No:

Select “Yes” when a subwoofer is connected, “No” when no

subwoofer is connected.

None:

Select this when no speaker is connected.

2sp / 1sp:

Select the number of surround back speakers.

A subwoofer with sufficient low frequency playback capability

can better handle deep bass than most main and surround

speakers, and the system’s overall performance will be greatly

enhanced when “Small” is set for the main (front) and surround

speakers.

When “Front” is set to “Small”, “Subwoofer” is automatically set

to “Yes”, and when “Subwoofer” is set to “No”, “Front” is

automatically set to “Large”.

Setting the Auto Surround Mode

Set whether or not to store the surround mode last played for the

input signal.

The surround mode used at last for the three types of input signals

shown below is stored in the memory, and the signal is automatically

played with that surround mode the next time it is input.

q Analog and PCM 2-channel signals (STEREO)

w 2-channel signals of Dolby Digital, DTS or other multi-channel

format (DOLBY PLII x Cinema)

e Multi-channel signals of Dolby Digital, DTS or other multi-

channel format (DOLBY/DTS SURROUND)

Default settings are indicated in ( ).

Press ENTER to enter the setting and switch to the

Speaker Setup.

Press

FF GG

to set.

1 2 A u t o S u r r . O F F

About the button names in this explanation

: Buttons on the main unit

[]: Buttons on the remote control unit

Button name only :

Buttons on the main unit and remote control unit

ENTER

D H F G

ENTER

[TEST TONE]

F G, ENTER

D H

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

Comments to this Manuals

No comments

Denon AVR-687 User Manual Page 48

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-687