Denon AVR-4308CI User Manual download pdf (Page 24)

Multi Zone

ZONE2 or ZONE3 Pre-out Connections

• If another power ampliﬁer or pre-main (integrated) ampliﬁer is connected, the ZONE2 or ZONE3 pre-out

(variable or ﬁxed level) connectors can be used to play a different program source in ZONE2 or ZONE3

the same time (vpage 70 ~ 74).

• When using a component video cable to connect the AVR-4308CI and input device, connect the ZONE2

monitor output to the component video connectors. When using an S-Video cable or a video cable, please

connect the cable to the video connectors.

• The ZONE2 video out is only for ZONE2.

"69

065

"6%*0

*/*/

7*%&0

"6%*07*%&0

$0.10/&/57*%&0

: 1# 13

Monitor (ZONE2)

Power amplier

(ZONE2 or ZONE3)

Input

Output

Infrared

retransmitter

Infrared

sensor

Extension jack for future use.

NOTE

• For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.

• For instructions on installing and operating separately sold devices, refer to the respective devices’

operating instructions.

•

To conduct multi-zone playback, see “Amp Assign / Multi-Zone Connections and Operations” (vpage 70 ~ 74).



Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting

External Controller

• When using in combination with an RF Remote Controller (RC-7000CI, sold separately) or RF Remote

Receiver (RC-7001RCI, sold separately) two-way communication with an RF Remote Controller is

possible.

The AVR-4308CI’s status information as well as iPod and Internet audio music ﬁles can be browsed

watching the RF Remote Controller’s display. For details, refer to the operating instructions of the

respective devices.

• When used in combination with an RF Remote Controller or RF Remote Receiver, make the settings at

GUI menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (vpage 36).

RS-232C connector

This connector is used for an external controller.

b If you wish to control the AVR-4308CI from

an external controller using the RS-232C

connector, perform the operation below

beforehand.

q Turn on the AVR-4308CI’s power.

w Turn off the AVR-4308CI’s power from the

external controller.

e Check that the AVR-4308CI is in the standby

mode.

Trigger output jacks

The power of an external device equipped with

a trigger input jack can be turned on and off in

association with operations on the AVR-4308CI.

For details, see GUI menu “Manual Setup” –

“Option Setup” – “Trigger Out 1” or “Trigger Out

2” (vpage 36).

• Output level: 150 mA/12 V

Check the trigger input conditions of the

connected device.

• If the trigger input level of the connected device

is higher than 150 mA/12 V and depending on

the short-circuiting conditions, the AVR-4308CI’s

protection circuit may be activated, in which case

“TRIGGER PROTECT” appears on the display. If

this happens, turn off the AVR-4308CI’s power

and disconnect the connected device.

1.AVR4308_P1~P27.indd 24 2008/02/14 10:44:22

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 109 110

Comments to this Manuals

No comments

Denon AVR-4308CI User Manual Page 24

Comments to this Manuals

Related products and manuals for Acoustics Denon AVR-4308CI