Denon PMA-720AE Owner's Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
11
Setting the Auto Standby mode
With the Auto Standby ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
•The default setting is “On”.
Press and hold AMP POWER X for at
least 5 seconds.
•Auto Standby mode is switched between
Off and On.
•The Power indicator indicates Auto Standby
mode Off/On during Standby, as shown
below.
Auto Standby mode “Off”
“Lit in red”
Auto Standby mode “On”
“Unlit”
•The Power indicator flashes in red during Auto Standby mode
setting.
If you set the Auto Standby mode while the unit is ON, the unit will
enter the standby mode as soon as the Auto Standby mode setting
is completed.
Adjusting the tone (LOUDNESS)
When the sound volume is low and you press LOUDNESS to the
hON” state, bass and treble sounds, which are hard to hear at a
low volume level, are enhanced so that you can enjoy a more natural
sound.
Press LOUDNESS on the main unit.
•Press the button again to the “jOFF” state to return to the
original balance.
Setting speakers to use
(PMA-720AE only)
Press SPEAKERS A or B on the main unit.
•When A (or B) is set to “hON”, sound is produced from the
speakers connected to the A (or B) speaker output terminals.
•When both A and B are set to “hON”, sound is produced from the
speakers connected to both the A and B speaker output terminals.
•When both A and B are set to “jOFF”, no sound is produced
from the speakers. Use this when listening over headphones.
Using headphones
Plug headphones into PHONES jack.
The speaker output turns off when the headphones are plugged in
(PMA-520AE only).
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
Starting recording
1
Press RECORDER.
2
Set the recorder to the record mode.
3
Start playing the source to be recorded.
NOTE
The recording source switches the input source select button (CD,
NETWORK, PHONO, AUX or TUNER) INPUT SELECTOR is operated
during recording.
Preparations
Operations
Information
Operations
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments