Denon DN-X1100 - DJ Mixer Owner's Manual download pdf (Page 9)



Getting Started Fader Start

ENGLISH

Speciﬁcations

Cables Used for Connections

Select the cables according to the equipment being

connected.

Preparations

Connections

NOTE

• Always switch on your audio input sources such

as CD players ﬁrst, then your mixer, and ﬁnally

any ampliﬁers.

• When turning off, always reverse this operation

by turning off ampliﬁers, then your mixer, and

then input units.

Refer to the Connection Diagram below.

1. Make certain AC power is off while making

connections.

2. Quality cables make a big difference in ﬁdelity

and punch. Use high-quality, audio cables.

3. Do not use excessively long cables.

Be sure plugs and terminals are securely

fastened. Loose connections cause hum,

noise, or intermittence that could damage your

speakers.

4. Connect all stereo input sources. Then connect

any effects into the stereo Effect, if used.

Connect your Microphone(s) and monitor

headphones. Make sure all faders are at “zero”

and the unit is off. Take care to connect only

one cable at a time. pay attention to L and R

position of terminals, on both the DN-X1100 and

outboard gear.

5. Connect the stereo outputs to the power

ampliﬁer(s) and/or tape deck(s) and/or MD

recorder(s) and/or CD recorder(s).

Audio cables

For RCA PINJACK

RCA pin plug

For SEND/RETURN

Unbalanced Unbalanced

For MIC

Balanced Balanced

1/4” TRS XLR3-11C Type

For BALANCED MASTER OUT

Balanced Balanced

1/4” TS 1/4” TS

1=GND

2=Hot

3=Cold

Ring=Cold

Tip=Hot

2=Hot

1=GND

3=Cold

Sleeve=GND

Ring=Cold

Tip=Hot

1/4” TRS

XLR3-11C Type

Main unbalanced

power amplifier

Main balanced power

amplifier

Balanced Microphones

CD player

1/4” TRS balanced

Tape deck

CD player

NOTE

Keep volume at comfortable sound levels and avoid extended play at very high volume as it may cause

temporary or permanent hearing loss.

CD player

Booth balanced/

power amplifier

Effects processor

Turntable 2

Turntable 1

Mic

XLR or 1/4” TRS balanced

DN-X1100

Turntable 3

Sleeve=GND

Connections

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Denon DN-X1100 - DJ Mixer Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for DJ controllers Denon DN-X1100 - DJ Mixer