Denon RCD-M39DAB Owner's Manual download pdf (Page 30)

Other functions

Using an optimizing ﬁlter

An optimizing ﬁlter suited for the properties of the speakers (SC-M39)

can be used.

Press SETUP.

Use ui to select “SPK

OPTIMISE”, then press the

ENTER or p.

Use ui to select “ON”, then press the ENTER or p.

The setting is entered.

The response is optimized for the speakers (SC-M39, sold

separately).

OFF

The response is ﬂat.

Auto power on

When the power is in standby, the power

turns on when any of the buttons below

other than POWER X is operated, and the

respective operation is performed.

•5 (on the main unit) ......... The disc tray opens.

•1/3 ................................. Playback of the “CD”, “iPod” or “USB”

starts.

•CD .................................... The source switches to “DISC”.

•TUNER.............................. The source switches to “TUNER” and the

band last set is tuned in.

•iPod/USB ......................... The source switches to “iPod/USB”.

•DIGITAL IN ....................... The source switches to “DIGITAL IN”.

•ANALOG IN ...................... The source switches to “ANALOG IN”.

Auto standby

With the Auto standby ON, this unit will automatically enter the

standby mode after about 30 continuous minutes of stop mode with

no operation.

For the input source “ANALOG IN” only, when no operation is

performed for eight hours, this unit automatically enters the standby

mode.

Press SETUP.

Use ui to select “AUTO

STANDBY”, then press ENTER

or p.

Use ui to select “ON”, then press ENTER or p.

The setting is entered.

NOTE

In the following situations, the Auto standby function does not operate.

•When an iPod (Remote mode) is connected to the USB port on the

unit.

•When the source is “TUNER”.

•The default setting for the Auto Standby mode is “ON”.

Last function memory

This stores the settings as they were immediately before going into

the standby mode.

When the power is turned back on, the settings are restored to as

they were immediately before going into the standby mode.

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations

cannot be performed.

When the microprocessor is reset, all the settings are reset to their

default values.

8/–SOURCE

Unplug the power cord.

Plug the power cord into a power outlet while

simultaneously pressing 8/– and SOURCE on the

main unit.

“INITIALIZE” is displayed.

If “INITIALIZE” does not display in step 2, start over from step 1.

Preparations

Informations

Operations

DISC

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Comments to this Manuals

No comments

Denon RCD-M39DAB Owner's Manual Page 30

Comments to this Manuals

Related products and manuals for Home audio sets Denon RCD-M39DAB