Denon AVR 1907 - AV Receiver Operations Instructions download pdf (Page 14)

Easy Setup Procedure Easy Setup Procedure

ENGLISH

Front A, Front B:

Assign to use the “Front A” or “Front B” speakers with bi-amp

connections.

Surround Back:

Assign to use as surround back speaker.

When assigned to “Front” or “ZONE2”, skip the surround back

channel measurement.

During the auto setup procedure, test tones are not output to

“ZONE2”.

ZONE2:

Assign to use as “ZONE2” speakers.

t Switching the front speaker

Press

DD HH

to select “Front Sp”, then press

FF GG

to select

the speaker.

Front A Front B Front A+B

y Starting Auto Setup

Press

DD HH

to select “Start”, then press

•Start the measurements.

Measurement of each channel is performed as follows:

FL FR C SW SL SR

SBL SBR

1 2

1: The subwoofer speaker is measured twice.

2: Not displayed when “ZONE2” and “Front” are set at

“Setting the Power Amplifier Assignment” ( page 53).

After each channel is measured, “Calculating” appears.

The display switches to the Auto Setup check screen

automatically.

NOTE:

• Do not change the speaker connections or subwoofer volume

after making the measurements.

• Do not turn off the power while the data is being stored.

Cautions during measurements:

• Loud test tones are output during the measurements. Be careful

for example when small children are nearby.

•Proper measurements may not be possible if there are obstacles

between the speaker and the setup microphone.

• During the measurements, do not stand between or near the

speakers and setup microphone.

•To avoid influencing the measurements, turn off the power of air-

conditioners or any other equipment producing sound in the

room. Perform the measurements with the room as quiet as

possible.

•Measurement is cancelled when VOLUME is operated while the

Auto Setup is performed.

e Perform the Auto Setup procedure

Press

DD HH

to select “Auto Setup”, then press ENTER.

Press SYSTEM SETUP.

Press

DD HH

to select “Auto Setup”, then press ENTER.

The message “Connect Microphone” is displayed if no

microphone is connected. If so, connect the auto setup

microphone.

• “System Setup” menu is not displayed when using headphones.

r Assigning power amplifiers

Press

DD HH

to select “Power Amp Assign”, then press

to set.

The surround back output can be assigned to the “Front” or “ZONE2”

output.

¢ About automatic retry

To confirm the results of the measurements, remeasurement is

automatically performed.

Remeasurement is performed up to two times. During this time,

“Retry1” or “Retry2” is displayed on the screen.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Comments to this Manuals

No comments

Denon AVR 1907 - AV Receiver Operations Instructions Page 14

Comments to this Manuals

Related products and manuals for Receiver Denon AVR 1907 - AV Receiver