Denon ADV-700 User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 168
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
36
4
Start playback on the selected component.
For operating instructions, refer to the components
manual.
The volume can be adjusted within the range of 60 to 0 to
18 dB. However, when the channel level is set as
described, if the volume for any channel is set at +1 dB or
greater, the volume cannot be adjusted up to 18 dB. (In this
case the maximum volume adjustment range is 18 dB
(Maximum value of channel level).)
5
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
M.VOLUME -20
MASTER VOLUME
Main unit
VOLUME
Remote control unit
The volume level is displayed
on the display.
NOTE:
The digital input indicator will light when DIG playing CD-
ROMs containing data other than audio signals, but no sound
will be heard.
Input mode when playing DTS sources
Noise will be output if DTS-compatible CDs or LDs are played in
the ANALOG or PCM mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to DTS.
Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
The DIG lights when digital signals are being input properly. If the
LED does not light, check whether the digital input component
setup and connections are correct and whether the components
power is turned on.
PRO LOGIC II
DIG
PCM
DIGITAL
DTS
DIG
PCM
DIGITAL
DTS
DIG
PCM
DIGITAL
DTS
AUTO
ANA
DIG
PCM DTS
ANA
DIG
PCM
AUTO
DTS
ANA
DIG
PCM
AUTO
DTS
ANA
DIG
PCM
AUTO
DTS
Input mode display
In the AUTO mode
In the DIGITAL PCM mode
In the DIGITAL DTS mode
In the ANALOG mode
One of these lights, depending on
the input signal.
Lit
One of these
lights,
depending on
the input signal.
Input signal display
DOLBY DIGITAL
DTS
PCM
STATUS
Main unit
FUNCTION
/SELECT
Main unit
STATUS
Remote control unit
2 Cheking the currently playing program source, etc.
Either press the STATUS button on the main unit then turn
the FUNCTION / SELECT dial or press the STATUS button
on the remote control unit to check the units operating
status.
ENGLISH
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 167 168

Comments to this Manuals

No comments