Denon AVR-2807 User Manual download pdf (Page 68)

ENGLISH

Operating the remote control unit Operating the remote control unit

Using the system call function

Press [SYSTEM CALL 1] for which you want to

• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.

Press the buttons you want to register in the

order of the operations to be performed.

Example: Press [ON].

↓↓

Press [CD] of [MODE SELECTOR].

↓↓

Press [1].

Repeat steps 3, 4 to register the desired buttons.

Registering

•A series of operations can be registered at a single button.

• This function makes it possible to for example turn the

amplifier’s power on, select the input source, turn the monitor

power’s on, turn the source device’s power on and start

playback, all by pressing a single button once.

• Up to 10 signals each can be stored at [SYSTEM CALL] (1 or 2).

• If your AV device is a brand other than DENON or if operation is

not possible using the preset memory function, the signals of a

remote control unit of that device can be stored in the AVR-

2807’s remote control unit.

• For some remote control units, it may not be possible to learn

the signals or the device may not operate properly after the

signals are learnt. In this case, use the remote control unit of

that device.

Setting the learning function

Press [USE/LEARN] with the tip of a pen etc., to

set the learn mode.

• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.

Press [MODE SELECTOR] for the device to be

operated.

• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.

•To cancel the learning function mode, press [USE/LEARN].

• If the codes could not be stored, the “LEARNED/TX” indicator

start flashing rapidly. For limited number of models, codes

cannot be stored in RC-1030.

• If [MODE SELECTOR] and the “LEARNED/TX” indicator start

flashing rapidly, this means that the memory is already full, and

the code you have just attempted to store was not stored.

To “learn” that code, first perform the resetting operation (

page 65).

Press the button to be set.

• The “LEARNED/TX” indicator stops blinking and [MODE

SELECTOR] lights.

If a button that cannot be learnt is pressed, [MODE SELECTOR]

and the “LEARNED/TX” indicator blinks.

Point the remote control units straight at each

other and press and hold in the button on the

other remote control unit to be learnt on the

AV R-2807’s remote control unit.

Other remote control unit

The AVR-2807’s remote control unit

(RC-1030)

Press [USE/LEARN].

Press [SYSTEM CALL] (1 or 2).

Operating

Press [SYSTEM CALL] (1 or 2) at which the operation

are registered.

• The stored signals are transmitted successively.

[MODE SELECTOR] and the “LEARNED/TX”

indicator lights, release the button on the other

remote control unit.

• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks

again.

Other buttons can be learnt by repeating steps 2 ~ 5.

Press [ON/SOURCE] and [POWER OFF] at the

same time.

• The “LEARNED/TX” indicator blinks.

Press [MODE SELECTOR] for the device to be

operated.

[POWER OFF]

[SYSTEM CALL]

[ ]

[USE/LEARN]

[ON/SOURCE]

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 87 88

Comments to this Manuals

No comments

Denon AVR-2807 User Manual Page 68

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-2807