39
ENGLISH
1
[5] Checking the currently playing program source, etc.
1
[4]
Combining the currently playing sound with the desired image
Cancelling simulcast playback.
• Select “SOURCE” using the VIDEO
SELECT button and the FUNCTION button.
• Switch the program source to the
component connected to the video input.
• Press the SOURCE button.
Simulcast playback
Use this switch to monitor a video source other
than the audio source.
Press the VIDEO SELECT button, turn the
FUNCTION knob until the desired source
appears on the display.
(Main unit)
On screen display
• Each time an operation is
performed, a description of
that operation appears on
the display connected to the
unit’s VIDEO MONITOR
OUT jack. Also, the unit’s
operating status can be
checked during playback by
pressing the remote control
unit’s ON SCREEN button.
Such information as the position of the input
selector and the surround parameter settings
is output in sequence.
Front panel display
• Descriptions of the unit’s
operations are also
displayed on the front panel
display. In addition, the
display can be switched to
check the unit’s operating
status while playing a
source by pressing the
STATUS button.
(Remote control unit)
(Main unit)
Using the dimmer function
• Use this to change the brightness
of the display.
The display brightness changes in
four steps (bright, medium, dim
and off) by pressing the main unit’s
DIMMER button repeatedly.
(Remote control unit)
[6] Switching the surround speakers
1
The surround speakers
switch as shown below each
time the SPEAKER button is
pressed.
SURROUND A SURROUND B
SURROUND A+B
This operation is possible when the setting
for using both surround speakers A and B
is made at “Speaker Config” in the
System Setup Menu.
(Remote control unit)
Playing one source while recording another (REC OUT mode)
Multi-source recording/playback
1
Press the ZONE2/3/REC
button until “ZONE2
SOURCE” appears on the
display.
NOTES:
• Recording sources other than digital inputs
selected in the REC OUT mode are also
outputted from the Zone2 preout jacks.
• Digital signals are not outputted from the analog
REC OUT jacks.
(Main unit)
2
With “ZONE2
SOURCE”displayed, turn the
FUNCTION knob until
“RECOUT SOURCE” appears
on the display.
With “RECOUT SOURCE”
displayed, turn the FUNCTION knob to select
the source you wish to record.
• When the FUNCTION goes around, it turn to
the “REC” indicator and the indicator of the
selected source light.
3
Set the recording mode.
• For operating instructions, refer to the manual
of the component on which you want to
record.
(Main unit)
4
To cancel, turn the function
knob.
(Main unit)
Comments to this Manuals