Denon AVR-5800 Operations Instructions download pdf (Page 18)

Before setting up the system

Check that all the connections are

correct, then turn on the main unit’s

power.

Either lightly press on the remote control unit’s touch panel

or press the LIGHT button to turn on the liquid crystal display.

(The back light does not turn on when the touch panel is

pressed.)

By default the liquid crystal display is set to display for 10

seconds, but this can be changed to approximately 120

seconds using the procedure described below so that

operations during system up can be performed securely.

Lightly press the remote control unit’s

jog stick (PUSH ENTER) to display the

icon display section.

Press the “ ” button in the icon display section to display

the “SETUP” icon.

Press the “SETUP” icon for at least 3 seconds to display

the setup screen.

Press the “ ” button in the icon display section to display

the “AVAMP” icon.

Press the “AVAMP” icon to display the page section.

ON / STANDBY

(Main unit)

Push the remote control unit’s jog

stick to the right to display the “SETUP

4/4” page.

Press the “LCD 10s” button on this

page so that this part is displayed in

half-tone dot mesh.

Now press the “•” button to set the

time display to “120”.

Push the remote control unit’s jog stick

to the right to display the “SETUP 3/5”

page.

Press “SYSTEM SETUP” at the bottom left to display the

“System Setup Menu” on the TV screen.

2, 5, 6, 7, 8

4, 7, 8

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

No comments

Denon AVR-5800 Operations Instructions Page 18