Denon AVR-5800 Operations Instructions download pdf (Page 79)

111 Changing the preset memory of preset devices

@I Touch the liquid crystal display to turn the

display on.

@ Press the JOG stick to display the icon display

sectron.

@ Press the - and v buttons in the icon

display section to display the “SETUP” rcon.

a. Display the “SETUP” icon in the rcon display

section, then press this “SETUP” rcon for at

least 3 seconds to drsplay the setup screen

(al.

Press the “Edrt Devrce” button on the

“Setup l/4” page to display the devrce

selection screen fb).

b. Press the icon in the icon display sectron for

the device whose preset memory you want

to change to display the brand selection

screen (12).

c. Use the - and - buttons on the

brand lrst to display the desired brand, then

press the “Brand name” button to display

the code selection screen (d).

d. Select and press the code number from the

code list. The transmission test screen ie)

appears.

e. Press the

“ON/OFF” button on the

transmrssion test screen to check the

operation of the device. (If the code is right,

the power of the device you are attempting

to operate should turn on and off.)

If the device has operated, press the “OK”

button to select that preset memory.

If the device has not operated, press the

“Cancel” button and try a different code.

If the desired preset code is not listed, press

the “CANCEL” button on the code selectron

screen (d) then select “NONE” at the very

bottom of the brand selection screen fc).

In thus case the preset memory IS not set.

f. Once “Setup Successful” ff) appears, the

preset memory IS set and the device

selection screen reappears.

When the “Cancel” button IS pressed at the

device selection screen, the setup screen

reappears. Press any icon other than “SETUP”

on the setup screen to cancel the setup mode

and return to the transmission screen.

Screen La)

Screen (ch

12

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 111 112

Comments to this Manuals

No comments