Denon AVR-786S Operations Instructions Page 40

  • Download
  • Add to my manuals
  • Print
  • Page
    / 66
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 39
Advanced Operation Advanced Operation
FUNCTION ZONE2/RECSELECT
POWER SPEAKER
If the indication on the display is not normal or if the operation of
the unit is not correct, then the microprocessor should be reset
by the following procedure.
Switch off th e unit using the main unit!s
POWER Switch.
Keep both SPEAKER A and B button s depressed
and turn on the unit by pressing the main unit,s
POWER Switck
a_ Chec k that the entire display is flashing at !:
second inter_als and release the buttons.
Tile microprocessor will be initialized:
Press the ZONE2/REC SELECTbutton to display
the "RECOUT SOURCE" on the display.
'_ The disola_ swltcnes as follows each time me Dultor s
0ressea.
ZONE2 REC
Turn the FUNCTION knob to select the source
you want to output appears on the display.
Set the recording mode.
This unit is equipped with a last function memory which stores
the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switched on.
The unit is also equipped with a back-up memory. This function
provides approximately one week of memory storage when the
main unit's POWER switch is off and the power supply cord
disconnected.
if step 3 does not work, start over from step 1.
If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
'_ Y-OI operating 9sTrucTIQnS refer to the manual o_ me
cor'nDoneni on wnlcn yOU ',A/anT TO recora
÷ To cance turn the FUNCTION knob and select "SOURCE".
Recording sources other than digital inputs selected in the REC
OUT mode are also output to the ZONE2 audio output
terminals.
Digital signals are net output to the REC SOURCE or audio
output terminals.
The DIGITAL IN's signal selected with the FUNCTION knob is
output to the DIGITAL OUT (OPTICAL) terminal.
37
I ENGLISH I
Page view 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 65 66

Comments to this Manuals

No comments