Denon AVR-786S Operations Instructions download pdf (Page 5)

Getting Started

Check that the following parts are included in addition to the main unit:

'_1_Operating instructions ............................ 1

_2];Wa rranty ................................................. 1

_3])Service station list .................................. 1

'% Remote centrol unit (RC-1003) ............... 1

'% R6P/AA batteries .................................... 2

_6)AM Ioep antenna .................................... 1

_7_FM indoer antenna ................................. 1

'_8_Omnidirectional micrephone ................... 1

Pay attentien te the fellowing before using this • Store these instructions in a safe place.

unit:

• Moving the unit

Te prevent short-circuits or damaged wires in •

the connection cables, always unplug the power

supply cord and disconnect the connection

cables between all other audio cemponents

when moving the unit.

• Before turning the power switch on

Check once again that all connections are

cerrect and that there are not problems with

the connectien cables. Always set the power

switch to the standby pesitien before

connecting and discennecting connection

cables.

After reading, stere this instructions along with

the warranty card in a safe place.

Note that the illustrations in these

instructions may differ from the actual unit

for explanation purposes,

V. AUX terminals

The AVR-786's front panel is equipped with V.

AUX terminals. Remove the cap cevering the

terminals when yeu want te use them.

_0 °

°o ooo _) o o

Getting Started

Noise or disturbance of the picture may be

generated if this unit or any other electrenic

equipment using microprocessers is used near

a tuner er TV.

If this happens, take the fellowing steps:

• Install this unit as far away as pessible

from the tuner er TV.

• Run the antenna wires from the tuner or

TV away from this unit's power supply cord

and input/eutput connection cables.

• Noise or disturbance tends to occur

particularly when using indeor antennas or

300 _/ohm feeder wires. We recommend

using outdoor antennas and 75 _/ohm

coaxial cables,

Note:

i Note

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar

enclosure,

• Switching the input source when input terminals are not connected,

A clicking noise may be produced if the input source is switched when nething is connected to

the input terminals. If this happens, either turn down the MASTER VOLUME control knob or

cennect compenents to the input terminals.

• Muting of PRE OUT terminals, PHONES jack and SPEAKER terminals.

The PRE OUT terminals, PHONES jack and SPEAKER terminals include a muting circuit. Because

ef this, the output signals are greatly attenuated fer several seconds after the power switch is

turned on or the input seurce, surround mode or any ether set-up is changed. If the volume is

turned up during this time, the eutput will be very high after the muting circuit stops functioning.

Always wait until the muting circuit turns eff before adjusting the w)lume.

• Whenever the power switch is in the STANDBY state, the unit is still connected to AC line

voltage.

Please be sure to turn off the power switch or unplug the cord when you leave home for,

say, a vacation.

The included remote control unit (RC-1003) can be used to operate net only the AVR-786 but other

remete control compatible DENON components as well, In addition, the memory centains centrol

signals fer other remote control units, se it can be used to operate nen-DENON remote centrol

compatible products.

I ENGLISH I

1 2 3 4 5 6 7 8 9 10 ... 65 66

Comments to this Manuals

No comments

Denon AVR-786S Operations Instructions Page 5

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-786S