Denon AVR-3600 User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
0 REMOTE CONTROL UNIT
Following the procedure outlined below, insert the batteries before using the remote control unît
M Range of operation of the remote control unit
Inserting the batteries
Point the remote control unit at the remote control sensor as shown on
the diagram at the left.
NOTES:
® The remote control unit can be used from a straight distance of
approximately 7 meters/20 feet, but this distance will shorten or op-
eration will become difficult if there are obstacles between the re
mote control unit and the remote control sensor, if the remote con
trol sensor is exposed to direct sunlight or other strong light, or if op
erated from an angle,
® Neon signs or other devices emitting puise-type noise nearby may
result in malfunction, so keep the set as far away from such devices
as possible.
NOTES:
» Use only AA, R6P, UM-3 batteries for replacement.
Be sure the polarities are correct, (See the illustration inside the bat
tery compartment,)
® Remove the batteries if the remote control transmitter wilt not be
used for an extended period of time.
a If batteries teak, dispose of them tmmediaieiy. Avoid touching the
leaked material or letting it come in contact with clothing, etc. Clean
the battery compartment thoroughly before installing new batter
ies,
® Have replacement batteries on hand so that the old batteries can be
replaced as quickly as possible when the time comes.
® The codes that have been learned may be lost if removed batteries
are not replaced within about 5 minutes.
7-1 System code buttons
DENON remote-controllable audio components can be controlled using this unit's remote control unit. Note
that some components, however, cannot be operated with this remote control unit.
1. Set to slide switch to "AUDIO" i"AVR/AVC")
AUDiO
2. Set the slide switch to the position for the
component to be operated (CD, DECK or
DAT), CD DECK DAT
AVR/AVC VIDEO
VDPVCR TV
3. Use the buttons shown below to operate the audio component.
For details, refer to the respective component's manual,
a. For CD players and DATs b. For tape decks (DECK)
ŒD GD CD\ CD
SYSTEhif QaU
V VOLUMSa
la a cdI
m
li
DISC
SKIP+
Manual search (reverse and forward)
Stop
Play
Auto search
Pause
Disc selection
(CD changer only)
7
volume *
_____
0!$C SKIfi
) C )^l )
B
¡""shift ... CHÀNNË1,
lo a al
; Reverse
: Forward
m : Stop
^ : Forward play
II : Pause
A/8 : A/B deck selection
^ : Reverse play
18
(Dtl
DENON teJFgom hc-S201
USei.eAtiN AWIQ.—
-----
..
0-- mn .Sigr
CID CD Cr> O
■ïvCz-rETiJ i'it» 1 '. .
tTvw ri5üF~ OswwEiZr'
I® Jo G3 CD
3
® ®
GüiTiS! ,y. ^
® ®, (ST
MOM
O CT CD
These buttons does not function.
(Some buttons can be used by using the pre
set memory or the learning function,}
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments