Denon AVR-1611 Owner's Manual download pdf (Page 11)

ENGLISH

Set up speakers (Audyssey

Auto Setup)

Preparation

If “Cancel” is selected

“Cancel Auto Setup?” is displayed on the TV

screen. If “Yes” is selected, “Audyssey Auto

Setup” closes.

NOTE

If “Caution” is displayed:

Go to “Error messages” (vpage 10), check

any related items, and perform the necessary

procedures.

If the problem is resolved, return and restart

“Audyssey Auto Setup”.

When performing Audyssey Auto

Setup over again

Press ui to select “Retry”, and then press

ENTER.

When measuring has stopped

q Press ui to select “Cancel”, then press

ENTER.

w Press o p to select “Yes”, then press ENTER.

Setting up the speakers again

Repeat the operation from step 4 of

Preparation

Remote control operation

buttons

Move the cursor

(Up/Down/Left/Right)

Conﬁrm the setting Return to previous menu

Step 1

Speaker Detection

Step 2

Measurement

The detected speakers are displayed.

Retry

[ENT]:Next

Front Sp. :Yes

Center Sp. :Yes

Subwoofer :Yes

Surround Sp. :Yes

Step1:Speaker Detection

MultEQ

NOTE

If a connected speaker is not displayed, the

speaker may not be connected correctly. Check

the speaker connection.

Use ui to select “Next” and then

press ENTER.

Move the setup microphone to

position 2, use ui to select “Next”,

and then press ENTER.

The measurement of the second position

starts. Measurements can be made in up to

six positions.

Step2:Measurement

MultEQ

Please place microphone

Cancel

[ENT]:Next

Calculate

2nd listening position.

at ear height at

If you want to omit measurements from the next

position onward, select “Calculate”.

(Go to

Step 3 Calculating

)

Repeat step 8, measuring positions 3

to 6.

When measurement of position 6 is

completed, a “All the measurements were

ﬁnished.” message is displayed.

Step2:Measurement

MultEQ

Retry

Cancel

[ENT]:Calculate

Calculate

All the measurements

were finished.

Connect the setup microphone to the

SETUP MIC jack of this unit.

3-1.Audyssey Auto Setup

MultEQ

at ear height at

ZONE2

Amp Assign:

Start

Cancel

[ENT]:Select [RTN]:Back

Please place microphone

main listening position.

When the setup microphone is

connected, the following screen is

displayed.

Here, we explain setup using the example of

5.1-channel speaker playback.

For settings other than 5.1-channel surround,

select “Amp Assign” and perform steps 3 to 4 of

“Set up speakers” (vpage31).

Use ui to select “Start” and then

press ENTER.

When measuring begins, a test tone is

output from each speaker.

• Measurement requires several minutes.

• In step 1, you will perform measurements at the main listening position.

• This step automatically checks the speaker conﬁguration and speaker size, and calculates the channel

level, distance, and crossover frequency. It also corrects distortion in the listening area.

• In step 2, you will perform measurements at

multiple positions (two to six positions) other than

the main listening position.

• You can achieve a more effective correction of

distortion within the listening area by performing

measurements at multiple positions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 77 78

Comments to this Manuals

No comments

Denon AVR-1611 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Receiver Denon AVR-1611