Denon POA-A1HD Owner's Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 117
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17

Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
Record Player
When connecting a record player with an MC cartridge, use a
commercially available MC head amplifier or a step-up transformer.
Induction humming (a booming sound) may be produced from the
speakers if the volume is raised with no record player connected.
With some record players, noise may be generated when the ground
wire is connected. If so, disconnect the ground wire.
(/%
"6%*0
065
R
L
Turntable (MM cartridge)
NOTE
The AVP-A1HD’s SIGNAL GND terminal is meant to reduce noise when
a record player is connected. This is not a safety ground terminal.
R
L
R
L
"6%*0
"6%*0
$0"9*"-
065
3-3-
065
9-3
065
CD Player
Connect the cables to be used.
CD player
iPod
®
Example :
R
L
R
L
"4%3
iPod
When using an optical cable or a BNC cable for the digital audio
connection, make the settings at GUI menu “Source Select” – “CD”
Assign” – “Digital” (vpage 44).
The default analog audio input setting is “RCA”. When using a balanced
cable for the analog audio connection, make the settings at GUI menu
“Source Select” – “CD” – “Assign” – “Analog” (vpage 44).
With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
To assign the iPod to a connector other than VCR (iPod), make the
settings at GUI menu “Source Select” “(input source to which iPod
dock assigned)” – Assign” – “iPod dock” (vpage 44).
Use a DENON Control Dock for iPod (ASD-1R, sold separately) to
connect the iPod to the AVP-A1HD. For instructions on the Control
Dock for iPod settings, refer to the Control Dock for iPod’s operating
instructions.
Connections
NOTE
The default AVP-A1HD balance model XLR input connectors pin
alignment is as shown.
q : GROUND
w : HOT
e : COLD
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 116 117

Comments to this Manuals

No comments