Denon AVR-1306 User Manual Page 20
- Page / 91
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
ENGLISH
17
ENGLISH
Basic Operation
Playing the input source
1
Select the input source to be played.
Example: CD
(Main unit) (Remote control unit)
2
Select the play (surround) mode.
Example: STEREO
4
Adjust the volume.
The volume can be adjusted within the range of –70 to 0 to
18 dB, in steps of 1 dB. However, when the channel level is
set as described ( page 27), if the volume for any
channel is set at +1 dB or greater, the volume cannot be
adjusted up to 18 dB. (In this case the maximum volume is
adjusted to “18 dB — (Maximum value of channel level)”.)
(Main unit) (Remote control unit)
The volume level is
displayed on the
master volume level
display.
Basic Operation
Playback
(Main unit) (Remote control unit)
SELECT
To select the surround mode while adjusting the surround
parameters, tone defeat or tone control, press the SURROUND
MODE button and then operate the selector.
Playback using the external input (EXT. IN)
terminals
Press the EXT. IN button to select the external input.
NOTE:
• When the input mode is set to the external input (EXT. IN),
the play mode (DIRECT, VIRTUAL SURROUND, STEREO,
STANDARD (DOLBY/DTS SURROUND), 5CH STEREO or
DSP SIMULATION) cannot be selected.
• In play modes other than the external input mode, the
signals connected to the EXT. IN terminals cannot be
reproduced. In addition, signals cannot be output from
channels not connected to the input terminals.
• Cancelling the external input mode:
Press the INPUT MODE or ANALOG button to switch to the
desired input mode ( page 18, 19).
• The external input mode can be set for any input source. To
watch video while listening to sound, select the input source to
which the video signal is connected, then set this mode.
• If the subwoofer output level is too high, set the “SW ATT.”
surround parameter to “ON”.
The signals being input to the external decoder input terminals
are played without passing through the surround circuitry.
SELECT
PHONES
SURROUND MODE
EXT. INSPEAKER
INPUT SELECTOR
MASTER VOLUME
ANALOG
INPUT MODE
VOLUME
DIMMER
EXT. IN
SPEAKER
MUTING
SURROUND
MODE
ANALOG
INPUT
SELECTOR
INPUT MODE
VIDEO SELECT
STATUS
3
Start playback on the selected component.
For operating instructions, refer to the component’s manual.
Press the MUTING button.
Turning the sound off temporarily (MUTING)
Use this to turn off the audio output temporarily.
• Canceling the MUTING mode:
q Press the MUTING button again.
w Press the VOLUME button on the remote control unit, or
adjust the volume up or down via the front panel MASTER
VOLUME knob.
- AVR-1306 1
- RISK OF ELECTRIC SHOCK 2
- DO NOT OPEN 2
- Systeminställningsmeny 3
- Getting Started 4
- Accessories 5
- Before using 5
- Cautions on installation 5
- Cautions on handling 5
- Part names and functions 6
- Front panel 6
- Inserting the batteries 6
- Easy Operation 7
- Speaker connections 8
- 2 Speaker impedance 8
- Protector circuit 8
- Note on speaker impedance 8
- 2 Connections 8
- CAUTION: 9
- POWER switch 10
- Connecting Other Sources 11
- Connecting a TV/DBS tuner 12
- Connecting a CD player 12
- Connecting a VCR 13
- 2 AM loop antenna assembly 13
- System Setup 14
- *Front L 3.6m 15
- *Subwoofer Yes 15
- II Cinema) 18
- System Setup System Setup 19
- Basic Operation 20
- IN=V SOURCE 21
- AUTO PCM DTS 21
- DIRECT/STEREO 22
- SURROUND PARAMETER 22
- STANDARD 22
- II Cinema mode) 23
- II Music mode) 23
- II Game mode) 23
- II Mode: 23
- INPUT SELECTOR 24
- INPUT MODE SELECT 24
- CINEMA EQ 25
- TONE DEFEAT 25
- OFFSET - 4dB 26
- DENON original surround modes 27
- 2 Personal memory plus 27
- SURROUND PARAMETER button to 28
- SELECT knob to set it 29
- CH SELECT 30
- CURSOR F 30
- CURSOR G 30
- TUNING (+) or (–) button 31
- BAND button to 31
- SHIFT RDS RT 32
- PRESET PTY 32
- Advanced Operation 34
- MODE 1 switch to “VIDEO” 37
- DVD/VDP POWER and TV POWER 37
- Troubleshooting 39
- Additional Information 40
- [2] DTS Digital Surround 42
- [3] DTS Neo:6™ surround 42
- Surround modes and parameters 43
- Specifications 44
- Erste Schritte 45
- Vor Inbetriebnahme 46
- Vorbereiten der Fernbedienung 46
- Vorderseite 47
- Einlegen der Batterien 47
- Einfacher Betrieb 48
- Lautsprecher-Anschlüsse 49
- 2 Impedanz der Lautsprecher 49
- Schutzschaltung 49
- 2 Anschlüsse 49
- VORSICHT: 50
- ON/STANDBY-Schalter am 51
- ON/SOURCE-Taste auf der 51
- SPEAKER A-Taste 51
- POWER-Schalter 51
- Anschluss anderer Quellen 52
- Anschluss eines TV/DBS-Tuners 53
- Anschluss eines CD-Players 53
- Anschluss eines VCR 54
- 2 MW-Rahmenantennenbaugruppe 54
- Systemsetup 55
- Systemsetup Systemsetup 60
- Grundlegender Betrieb 61
- II Cinema-Modus) 64
- II Music-Modus) 64
- II Game-Modus) 64
- II-Modus: 64
- 2 Persönlicher Speicher Plus 68
- SURROUND PARAMETER-Taste 69
- SELECT-Knopfes an 70
- ENTER-Taste, um den Surround 70
- POWER-Schalter am Hauptgerät 72
- TUNING (+)- oder (–)-Taste 72
- MODE-Taste, um den 72
- (Hauptgerät) (Fernbedienung) 74
- Erweiterter Betrieb 75
- MODE 1-Schalter auf “VIDEO” 78
- MODE 2-Schalter auf die zu 78
- DVD/VDP POWER 78
- TV POWER-Taste 78
- POWER-Schalters aus 79
- SPEAKER A- und B-Taste 79
- Fehlersuche 80
- [1] Grundeinstellung 81
- Surround- Lautsprecher 81
- [2] DTS-Digital Surround 83
- 2 DTS-kompatible Medien und 83
- Wiedergabeverfahren 83
- Surround-Modi und Parameter 84
- Technische Daten 85
- TOKYO, JAPAN 91
Related products and manuals for Receivers and Amplifiers Denon AVR-1306
(2 pages)
(37 pages)
(168 pages)© 2020, manymanuals.com. All rights reserved. | 1.788 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals