Denon AVR-1306 User Manual download pdf (Page 21)

ENGLISH

Basic Operation Basic Operation

ENGLISH

Press the VIDEO SELECT button repeatedly until the

desired source appears on the display.

Combining the currently playing sound with

the desired image (VIDEO SELECT)

Use this switch to monitor a video source other than the

audio source.

IN=V SOURCE

• Canceling simulcast playback:

q Select “SOURCE” by pressing the VIDEO SELECT button.

w Switch the program source to the component connected to

the video input terminals.

Press the SPEAKER A or B button to turn the

corresponding speaker pair on.

The front speaker A, B setting can be also be changed with

the SPEAKER button on the remote control unit.

Selecting the front speakers

Connect the headphones to the PHONES jack.

• The speaker output is automatically turned off when headphones

are connected.

NOTE:

•To prevent hearing loss, do not raise the volume level

excessively when using headphones.

Listening over headphones

Checking the currently playing program

source

2 Front panel display

Press the STATUS button.

Descriptions of the unit’s operations are also displayed on

the front panel display. In addition, the display can be

switched to check the unit’s operating status while playing

a source.

2 Using the dimmer function

Press the DIMMER button.

The display brightness changes in four steps (bright, medium,

dim and off).

AUTO (auto mode):

In this mode, the types of signals being input to the digital and

analog input terminals for the selected input source are

detected and the program in the AVR-1306’s surround

decoder is selected automatically upon playback. This mode

can be selected for all input sources other than TUNER.

The presence or absence of digital signals is detected, the

signals input to the digital input terminals are identified and

decoding and playback are performed automatically with the

DTS, Dolby Digital or PCM (2 channel stereo) format. If no

digital signal is being input, the analog input terminals are

selected.

Use this mode to play Dolby Digital signals.

DTS (exclusive DTS signal playback mode):

Decoding and playback are only performed when DTS signals

are being input.

PCM (exclusive PCM signal playback mode):

Decoding and playback are only performed when PCM signals

are being input.

Note that noise may be generated when using this mode to

play signals other than PCM signals.

AUTO PCM DTS

Press the INPUT MODE button.

The mode switches as shown below each time the INPUT

MODE button is pressed:

Input mode

The AVR-1306 has an AUTO signal detection mode that

automatically identifies the type of incoming audio signals, but is

also equipped with a manual mode that can be switched

according to the type of input audio signals.

2 Selecting the AUTO, PCM and DTS modes

Press the ANALOG button to switch to the analog

input.

2 Selecting the analog mode

ANALOG (exclusive analog audio signal playback mode):

The signals input to the analog input terminals are decoded

and played.

NOTE:

• Input mode when playing DTS sources:

Noise will be output if DTS-compatible CDs or LDs are

played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect

the source component to the digital input terminals

(OPTICAL/COAXIAL) and set the input mode to “DTS”.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 90 91

Comments to this Manuals

No comments

Denon AVR-1306 User Manual Page 21

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-1306