Denon AVR-2802/982 User Manual download pdf (Page 12)

ENGLISH

Speaker system connections

• Connect the speaker terminals with the speakers making sure that

like polarities are matched (≈ with ≈ , √ with √ ). Mismatching of

polarities will result in weak central sound, unclear orientation of

the various instruments, and the sense of direction of the stereo

being impaired.

• When making connections, take care that none of the individual

conductors of the speaker cord come in contact with adjacent

terminals, with other speaker cord conductors, or with the rear

panel.

NOTE:

NEVER touch the speaker terminals when the power is on.

Doing so could result in electric shocks.

Speaker Impedance

• Speakers with an impedance of from 6 to 16 Ω/ohms can be

connected for use as front and center speakers.

• Speakers with an impedance of 6 to 16 Ω/ohms can be connected

for use as surround and surround back speakers.

• Be careful when using two pairs of front speakers (A + B) at the

same time, since use of speakers with an impedance of less than

8 Ω/ohms will lead to damage.

• The protector circuit may be activated if the set is played for long

periods of time at high volumes when speakers with an impedance

lower than the specified impedance are connected.

Connection the speaker terminals

1. Loosen by turning

counterclockwise

2. Insert the cord. 3. Tighten by turning

clockwise.

Connecting banana plugs

banana plug

Turn clockwise to tighten, then insert the

banana plug.

• This unit is equipped with a high-speed protection circuit. The purpose of this circuit is to protect the speakers under

circumstances such as when the output of the power amplifier is inadvertently short-circuited and a large current flows, when

the temperature surrounding the unit becomes unusually high, or when the unit is used at high output over a long period

which results in an extreme temperature rise.

When the protection circuit is activated, the speaker output is cut off and the power supply indicator LED flashes. Should

this occur, please follow these steps: be sure to switch off the power of this unit, check whether there are any faults with

the wiring of the speaker cables or input cables, and wait for the unit to cool down if it is very hot. Improve the ventilation

condition around the unit and switch the power back on.

If the protection circuit is activated again even though there are no problems with the wiring or the ventilation around the

unit, switch off the power and contact a DENON service center.

Protector circuit

• The protector circuit may be activated if the set is played for long periods of time at high volumes when speakers with an

impedance lower than the specified impedance (for example speakers with an impedance of lower than 4 Ω/ohms) are

connected. If the protector circuit is activated, the speaker output is cut off. Turn off the set’s power, wait for the set to cool

down, improve the ventilation around the set, then turn the power back on.

Note on speaker impedance

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 72 73

Comments to this Manuals

No comments

Denon AVR-2802/982 User Manual Page 12

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-2802/982