Denon AVR-2802/982 User Manual download pdf (Page 22)

ENGLISH

Set the distance between the

center speaker and listening

position.

The distance changes in units of 1

foot (0.1 meters) each time the

button is pressed. Select the value

closest to the measured distance.

If “Yes” is selected for “Default”, the settings are automatically reset

to the default values.

Please note that the difference of distance for every speaker should be 15

ft (4.5 m) or less. If you set an invalid distance, a CAUTION notice, such as

screen right will appear. In this case, please relocate the blinking speaker(s)

so that its distance is no larger than the value shown in highlighted line.

Example: When the distance is set to 12 feet

for the center speaker

ENTER

Enter the setting.

The System Setup Menu reappears.

The AVR-2802/982 automatically sets the optimum surround delay time for the listening room.

NOTE:

• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 16).

ENTER

At the System Setup Menu select “Channel Level”.

Switch to the Channel Level screen.

Select “Test Tone Mode”.

Setting the channel level

• Use this setting to adjust so that the playback level between the different channels is equal.

• From the listening position, listen to the test tones produced from the speakers to adjust the level.

• The level can also be adjusted directly from the remote control unit. (For details, see page 42.)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 72 73

No comments

Denon AVR-2802/982 User Manual Page 22