•
The recorded medium does not have sufficient
performance (speed) to keep up with the set’s
reading speed.
ENGLISH
34
Check the following before assuming there is a problem with the set.
If this does not solve the problem, there may be a problem with the set. Turn off the power and unplug the power cord, then contact your
store of purchase.
16
TROUBLESHOOTING
Symptom Possible problem Remedy
Power does not turn on.
•
AC adapter is not properly connected.
•
Check the connection.
• Power switch is set to “OFF”. • Turn on the power switch on the set's rear panel.
Buttons do not function.
• The key lock mode has been set by serial
command.
• Use a serial command to cancel the key lock
mode.
•
An FTP “SITE” command is being executed.
•
Use an FTP “SITE” command to cancel the key
lock mode.
• A script file is playing. • Press the STOP key for at least 2 seconds to
cancel the script.
“Reboot!!!” has appeared
momentarily on the monitor display
or has appeared does not turn off.
• Reboot has been executed by serial command. • Turn the power switch on the set's rear panel off
once, then back on.
“!” displayed on the OSD even
when the SELECT button is pressed.
•
A prescribed directory has not been created.
•
Create all the prescribed directories (VIDEO,
AUDIO, PICTURE SCRIPT and AVDATA).
File cannot be played.
• File is damaged.
• Reformat the recording medium.
The data is lost when the medium is formatted.
• The file format is not one that can be played on
this set.
• Create a file in a format that can be played on this
set.
Picture playback stops in the middle
or is interrupted.
•
Use a recommended card.
• Use a bit rate lower than the maximum rate (by
“TE” command).
Recorded medium is not recognized.
• The medium is not formatted.
• Format the medium.
The data is lost when the medium is formatted.
•
The format of the medium is not a format
compatible with this set.
If the set’s access LED flashes repeatedly and
the medium is not recognized though it is
recognized on a computer, etc., it may be
formatted in NTFS or super floppy format.
•
Use the set’s serial control command to format
the medium on the set.
The data is lost when the medium is formatted.
General operation
Comments to this Manuals