Denon S-32 User Manual download pdf (Page 29)



Getting Started Connections Setup Playback Information

ENGLISH

Troubleshooting

Symptom Cause Countermeasure Page

For some

radio stations,

“Server Full”

or “Connection

Down” is

displayed and

station cannot be

connected to.

• Station is congested or not

currently broadcasting.

• Wait a while before trying again. –

Sound is broken

during playback.

• Network’s signal transfer speed

is slow or communications lines

or radio station is congested.

• This is not a malfunction. When

playing broadcast data with a

high bit rate, the sound may

be broken, depending on the

communications conditions.

–

Sound quality is

poor or played

sound is noisy.

• File being played has a low bit

rate.

• This is not a malfunction. –

Symptom Cause Countermeasure Page

Continuous noise

is heard when

receiving FM

programs

• Antenna cable is not properly

connected.

• Connect the antenna cable

properly.

• Connect an outdoor antenna.

5

5

Hissing or

continuous noise

is heard when

receiving AM

programs

• This may be noise from a TV or

interference from a radio station.

• Turn off the TV.

• Change the position and direction

of the AM loop antenna.

–

–

GTunerH

GWireless LANH

Symptom Cause Countermeasure Page

Cannot connect

to network.

• The settings of the SSID

and network key (WEP) are

incorrect.

• The reception is poor and the

signals cannot be received.

• There are multiple networks and

the usable channels overlap.

• Match the network settings with

the S-32’s settings.

• Shorten the distance from the

wireless LAN’s access point,

remove any obstacles and

otherwise improve visibility, then

try reconnecting. Also install

away from microwave ovens

and the access points of other

networks.

• Set the access point’s channel

settings away from the channels

used for other networks.

Alternatively, connect using a

network cable.

6

–

–

Played sound is

interrupted or

sound cannot be

played.

• There are multiple networks and

the usable channels overlap.

• Set the access point’s channel

settings away from the channels

used for other networks.

Alternatively, connect using a

network cable.

–

1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments