Denon AVR 1906 - AV Receiver Operations Instructions download pdf (Page 50)

ENGLISH

Advanced Setup – Part 2 Advanced Setup – Part 2

ENGLISH

-1

When “Auto” mode is selected:

Press the CURSOR

button to adjust all

the speakers to the same volume.

• The test tones are emitted from each speaker in the

following order: at 4-second intervals during the first and

second cycle, and at the 2-second intervals during the

third and subsequent cycles.

1sp

2sp

SBL

SBR

When the surround back speaker setting is set to

“1sp” for “Speaker Configuration”, this is set to “SB”.

Example:

When the volume is set to –12 dB while the test tone is

being produced from the Front Lch speaker

-2

When “Manual” mode is selected:

Press the CURSOR

button to select the

speaker, then press the CURSOR

button

to adjust all the speakers to the same volume.

The volume can be adjusted between –12 dB and +12

dB in units of 1 dB.

Press the ENTER button to enter the setting.

• The “Speaker Setup” menu appears.

•To cancel the settings, press the CURSOR

button to select

“Level Clear” on the “Channel Level” screen, then make the

settings again.

•When adjusting the level of an active subwoofer system, you

may also need to adjust the subwoofer’s own volume control.

•When you adjust the channel levels while in the system setup

channel level mode, the channel level adjustments made will

affect all surround modes. Consider this mode a master

channel level adjustment mode.

• After you have completed the system setup channel level

adjustments, you can then activate the individual surround

modes and adjust channel levels that will be remembered for

each of those modes. Then, whenever you activate a particular

surround sound mode, your preferred channel level

adjustments for just that mode will be recalled. Check the

instructions for adjusting channel levels within each surround

mode ( page 28).

2 Adjusting the test tone

• Before playing with the surround function, be sure to use the

test tones to adjust the playback level from the different

speakers. This adjustment can be performed with the system

setup ( page 46, 47) or from the remote control unit, as

described below.

• Adjusting with the remote control unit using the test tones is

only possible in the “Auto” mode and only effective in the

STANDARD (DOLBY/DTS SURROUND) modes. The adjusted

levels for the different modes are automatically stored in the

memory.

Press the TEST TONE button.

•Test tones are output from the different speakers.

Press the CURSOR

button to adjust so

that the volume of the test tones is the same for

all the speakers.

After completing the adjustment, press the

TEST TONE button again.

Press the STANDARD button to select the

STANDARD (DOLBY/DTS SURROUND)

modes.

Set the crossover frequency mode according to the speaker

system being used.

Setting the Crossover Frequency

Press the CURSOR

button to select

“Crossover Frequency” at the “Speaker Setup”

menu, then press the ENTER button.

• The “Crossover Frequency” screen appears.

Press the CURSOR

button to select the

frequency.

40 / 60 / 80 / 100 / 120 / 150 / 200 / 250 Hz can be selected.

Press the ENTER button to enter the setting.

• The “Speaker Setup” menu appears.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 69 70

Comments to this Manuals

No comments

Denon AVR 1906 - AV Receiver Operations Instructions Page 50

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR 1906 - AV Receiver