Denon AVR 2805 - AV Receiver Operations Instructions download pdf (Page 21)

Place the microphone for Auto Setup at the actual listening

position which will be at the same height as your ears. Use a

tripod or level surface at positioning.

Auto setup/Room EQ

Connect the microphone for Auto Setup to the Setup Mic

connector on the front panel of the unit.

The Auto Setup function of this unit performs an analysis of the speaker system and measures the acoustic characteristics of your room to permit

an appropriate automatic setting.

When performing Auto Setup, an optional microphone is required for the setup.

2 Measurement and setting details

q : This sets the speaker connection mode, polarity, and bass reproduction ability.

w : This sets the optimum delay time from each speaker corresponding to the listening position.

e : This sets the volume that is output from each speaker.

r : This sets the frequency response of each speaker.

NOTE:

• A loud test tone is output during the measurement. Please consider this should you be planning night time measurements, and consider not

allowing small children into the listening room at this time.

MODE ANALOG EXT. IN

Listening position

Setting the Auto Setup / Room EQ

Display the Auto Setup / Room EQ menu.

Select “Auto Setup / Room EQ” at the System Setup Menu.

(Remote control unit)

Auto Set/RoomEQ

*System Setup

(Remote control unit)

Connecting the microphone for Auto Setup

NOTES:

• When using other microphone see page 28.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 99 100

No comments

Denon AVR 2805 - AV Receiver Operations Instructions Page 21