Denon AVR-3801 Operations Instructions Page 43

  • Download
  • Add to my manuals
  • Print
  • Page
    / 71
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 42
43
LOCK
SIGNAL
DIGITAL
LOCK
SIGNAL
DIGITAL
LOCK
SIGNAL
DIGITAL
ANALOGDIGITAL
DIGITAL
DIGITAL
ANALOG
AUTO
INPUT
PCM DTS
AUTO
INPUT
PCM DTS
AUTO
INPUT
PCM DTS
AUTO
INPUT
PCM DTS
PCM
Selecting the PCM mode
Press the PCM button to switch to the PCM signal input.
DTS
Selecting the DTS mode
Press the DTS button to switch to the DTS signal input.
3
Example: Stereo
Select the play mode.
SURROUND
MODE
STEREO
(Main unit) (Remote control unit)
4
Start playback on the selected component.
For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
MASTER VOLUME
VOLUME
+
-
The volume level is
displayed on the
master volume level
display.
(Main unit) (Remote control unit)
The volume can be adjusted within the range of –60 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 23 or pages 49 and 50, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is “18 dB — (Maximum value of channel level)”.)
Input mode when playing DTS sources
Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.
Input mode display
In the AUTO mode
In the DIGITAL PCM mode
In the DIGITAL DTS mode
In the ANALOG mode
One of these lights, depending on the
input signal.
Input signal display
DOLBY DIGITAL
DTS
PCM
The LOCK LED lights when digital signals are being input properly.
If the LED does not light, check whether the digital input
component setup (page 25) and connections are correct and
whether the component’s power is turned on.
NOTE:
• The digital input indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
(Main unit)
(Main unit)
SELECT
To select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the
surround mode button then operate the selector.
SURROUND
MODE
(Main unit)
Page view 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 70 71

Comments to this Manuals

No comments