Denon AVR-X500 Owner's Manual download pdf (Page 29)

Connecting the speaker cable

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being

connected to the this unit, and be sure to connect the channels and polarities correctly.

Peel o about 10 mm of sheathing from the tip of the speaker

cable, then either twist the core wire tightly or terminate it.

Press the lever on the speaker terminal.

Holding the lever on the speaker terminal, insert the core wire of

the speaker cable all the way into the speaker terminal.

Release your ﬁnger from the lever on the speaker terminal.

Speaker connection

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

•For TV connections, see “Connecting this unit to a TV via HDMI connections” (vpage 6) or

“Connecting a TV” (vpage10).

n Connecting 5.1-channel speakers (vpage28)

n Connecting 2.1-channel speakers (vpage28)

NOTE

•Disconnect this unit’s power plug from the power outlet before connecting the speakers. Also,

turn o the subwoofer.

•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The

protection circuit may be activated if the core wires touch the rear panel or if the + and – sides

touch each other (vpage56 “Protection circuit”).

•Never touch the speaker terminals while the power cord supply is connected. Doing so could

result in electric shock.

•Use speakers with the speaker impedances shown below.

Speaker terminals Speaker impedance

FRONT

6 – 16 Ω/ohmsCENTER

SURROUND

Basic instructions

Advanced instructions

Information

Advanced instructions

DVD

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 65 66

No comments

Denon AVR-X500 Owner's Manual Page 29