I=IK.'I| E.'_"
Either turn the SURROUND/SELECT dial or press the
SURROUND button on the remote control unit to select the
surround mode.
Main unit Remote control unit
• The function switches as shown below.
• The function only changes in the "-->" direction when
operated from the remote control unit.
DOLBY VS _ STEREO _ DIRECT _ ROCK ARENA
"_-_ JAZZ CLUB _-_ VIDEO GAME _-_ DOLBY VS ....
Start playback on the selected component.
• For operating instructions, refer to the component's
R]anual,
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the w)lume.
J ........ ...,.........,....... ...:,_The volume level is displayed
_-_,.,..,L.....uv.:::.'"::"::" Ion the display.
VOLUME
Main unit Remote control unit
• The volume can be adjusted within the range -60 to 0 to
+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may
not be possible to adjust the volume up to +18 dB.
• To check the currently playing program source, etc.
Press the MENU/SET button. Display "STATUS" then turn
the SURROUND/SELECT control.
Main unit Main unit Remote control unit
÷ To perform this operation on the remote control unit, press
the STATUS button.
The current program source and surround settings are shown
on the display each time the button is pressed or turned.
(When the function is set to DVD, the information is also
displayed on the TV screen.)
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
One of these lights, depending on
the input signal.
:_DIG - _ /
I _ DTS
-- ANA_
• In the ANALOG mode _ _
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
.0 ¸_.-_ i< _;_i::
' }i! ii i
I " i¸ii¸¸'i{3:¸VilDL_
• "DIG" lights when digital signals are input properly, if "DIG" is
flashing, check whether the connections are proper and whether
the input cemponent's power is on.
Input mode when playing CD sources
• When playing CDs containing recordings of live concerts, etc., in
the "AUTO" mode, the sound may be slightly broken at the
beginning. If this happens, switch to the "PCM" mode.
Input mode when playing DTS sources
• If DTS-compatible CDs are played in the "PCM" mode, noise is
output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to "AUTO" or "DTS".
• Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
45
Comments to this Manuals