Denon S-302 User Manual download pdf (Page 13)



Setup Playback Remote Control Information Troubleshooting

ENGLISH

Audio cables Video cables

Coaxial digital connections

(Orange)

Coaxial digital (75Ω / ohms pin-plug) cable

Optical digital connections

Optical transmission cable

Analog connections (stereo)

(White)

(Red)

Stereo pin-plug cable

Network connections (wired LAN)

LAN cable

Component video connections

(Green)

(Blue)

(Red)

(Y)

(PB/CB)

(PR/CR)

Component video cable

S-Video connections

S-Video cable

Video connections

(Yellow)

75Ω / ohms pin-plug video cable

Audio and video cables

HDMI connections

19-pin HDMI cable

Signal direction

Audio signal: Video signal:

Output

Input

Output

Input

Output

NOTE

• Do not plug in the power supply cord until all connections have been

completed.

• When making connections, also refer to the owner’s manual of the

other components.

• Be sure to connect the left and right channels properly (left with left,

right with right).

• Do not bundle power supply cords together with connection cables.

Doing so can result in humming or noise.

Select the cables according to the equipment being connected.

Connections

Connections for all compatible audio and video signal formats are

described in these operating instructions. Please select the types

of connections suited for the equipment you are connecting.

With some types of connections, certain settings must be made

on the S-302. For details, refer to the instructions for the respective

connection items below.

Preparations

Cables Used for Connections

To change the speaker cable

Refer to the procedure below if you want to switch to a different

speaker cable. This example describes how to mount the “+” side

cable to the connector. Mount the “–“ side cable in the same way.

 Insert the included hexagonal wrench into the hole at

the side of the connector’s “+” side. (Arrow A)

Turn the hexagonal wrench in the direction of arrow

B to loosen the cable.

Pull out the old cable. (Arrow C)

b Be careful not to leave any broken wire parts inside the

connector.

Peel off the cable’s sheath and insert the new cable .

(Arrow D)

Turn the hexagonal wrench in the direction of Arrow

E and tighten securely so that the cable cannot be

pulled out.

b If the polarities are inverted, the phase

may be off and the bass sound may

be missing, resulting in an unnatural

sound.

Getting Started Connections

1.S-302E3_1st.indd 13 2007/07/31 17:44:31

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Comments to this Manuals

No comments

Denon S-302 User Manual Page 13

Comments to this Manuals

Related products and manuals for Receiver Denon S-302