Denon AVR-887 User Manual download pdf (Page 28)

ENGLISH

Basic Operation

Playing the input source

Use FUNCTION to select the input source you want to

play.

To select the input source when ZONE2/REC SELECT is

selected, press

MAIN

then operate

FUNCTION

Start playback on the selected component.

For operating instructions, refer to the component’s manual.

Press INPUT MODE.

• The input mode indicator lights.

AUTO (All auto mode):

The type of input signal is detected and the AVR-887’s surround

mode is switched automatically. Can be selected for sources for

which the “Digital In Assignment”

(

page 49) is made.

The mode switches automatically to DTS / Dolby Digital / PCM.

The input switches to the analog input terminals is no digital signals

are being input.

ANALOG (exclusive analog audio signal playback mode) and

EXT. IN (External decoder input terminal selection mode):

The signals input to the various input terminals are played.

PCM (exclusive PCM signal playback mode) and

DTS (exclusive DTS signal playback mode):

Played when the various signals are input. Noise may be generated

when a mode different from the input signal is set.

AUTO

EXT. IN ANALOG

PCM DTS

Use VOLUME to adjust the volume.

• The volume level is displayed on the master volume level display.

The volume can be adjusted between the range of –80 ~ 0 ~ 18

dB. Depending on the channel level settings and the different

surround mode settings and when in the down-mix mode, it may

not be possible to adjust the volume to 18 dB.

NOTE:

• When the input mode is set to the external input (EXT. IN), the

surround mode cannot be set.

• In play modes other than the external input mode, the signals

connected to these terminals cannot be played.

Cautions when playing DTS sources:

• For DTS sources, be sure to connect the device to the digital

input terminal and set “AUTO” or “DTS” for the input source.

Noise will be generated if you play in the “ANALOG” or “PCM”

mode.

• When playing DTS signals in the “AUTO” mode, noise may be

generated when you first start playing and during searching. If so,

play in the “DTS” mode.

• Canceling the EXT. IN mode:

Press INPUT MODE or

ANALOG

to switch to the desired input mode.

•To use the EXT. IN mode together with a picture, select the input source

to which the video signal is connected first, then set the input mode.

• The “DIGITAL” indicator lights when digital signals are being input

properly. If the “DIGITAL” indicator does not light, check whether

the “Digital In Assignment” ( page 49) and connections are correct.

Press

ANALOG

to select “ANALOG”,

EXT. IN

to select “EXT.

IN”.

To lower the subwoofer channel level in the EXT. IN mode, press

SURROUND PARAMETER and select “SW. ATT”.

For some players the playback level of the SW channel may seen

strong. If so, set to “ON”.

About the button names in this explanation

<>: Buttons on the main unit

[]: Buttons on the remote control unit

Button name only :

Buttons on the main unit and remote control unit

[MUTING]

STATUS

DIMMER

FUNCTION

[ON SCREEN]

VOLUME

INPUT MODE

FUNCTION

SURROUND

PARAMETER

FUNCTION <ANALOG> VOLUMEDIMMER

STATUS<EXT. IN>INPUT MODE

<MAIN> SURROUND PARAMETER<SPEAKER>

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 81 82

Comments to this Manuals

No comments

Denon AVR-887 User Manual Page 28

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-887