Denon PMA-SA1 User Manual download pdf (Page 10)

10

ENGLISH ENGLISH

3

OPERATION

(Refer to page 5.)

PREPARATION

1. CHECKING CONNECTIONS

• Make sure that all the connections are proper by referring

to the rear panel.

• Check the polarity (positive and negative) of connections,

and the directivity of stereo separation (right cord to right

channel terminal, and left cord to left channel terminal).

• Check the directivity of pin plug cord connection.

2. SETTING OF EACH KNOB

•Turn the VOLUME knob

t counterclockwise, to minimum

position.

After checking the above items, turn on the power, the amplifier

is set in the ready mode in a few seconds.

PLAYING A RECORD

1. Set the EQ POWER switch e to “ON”.

2. Set the INPUT SELECTOR switch

i to “PHONO”.

3. Operate the turntable and play the record.

4. Turn the VOLUME knob

t to yield an appropriate volume.

PLAYING CD PLAYER

1. Set the INPUT SELECTOR switch i to “CD-1”.

2. Operate the CD player.

3. Turn the VOLUME knob

t to yield an appropriate volume.

PLAYING CD PLAYER

1. Set the INPUT SELECTOR switch i to “CD-2”.

2. Operate the CD player.

3. Turn the VOLUME knob

t to yield an appropriate volume.

RECEPTION OF RADIO PROGRAMS

1. Set the INPUT SELECTOR switch i to “TUNER”.

2. Operate the tuner to receive a radio program.

3. Turn the VOLUME knob

t to yield an appropriate volume.

PLAYING AUDIO EQUIPMENT CONNECTED TO

DVD/AUX TERMINALS

1. Set the INPUT SELECTOR switch i to “DVD/AUX” position.

2. Operate the Audio equipment.

3. Turn the VOLUME knob

t to yield an appropriate volume.

PLAYING AUDIO EQUIPMENT CONNECTED TO

BALANCED INPUT TERMINALS

1. Set the BALANCED INPUT switch y to “ON”.

2. Operate the Audio equipment.

3. Turn the VOLUME knob

t to yield an appropriate volume.

PLAY BACK WITH TAPE DECK

1. Set the INPUT SELECTOR switch i to “TAPE-1/CD-R” or

“TAPE-2/MD”.

2. Operate the tape deck.

3. Turn the VOLUME knob

t to yield an appropriate volume .

RECORDING WITH TAPE DECK

1. Set the BALANCED INPUT switch y and INPUT SELECTOR

switch

i to the program source you wish to record.

2. Set the REC OUT SELECTOR switch

u to “SOURCE”.

3. Play back the program source.

4. Start recording with the component connected to “TAPE-

1/CD-R” or “TAPE-2/MD”.

COPYING FROM ONE TAPE TO ANOTHER

To copy from TAPE-1/CD-R to TAPE-2/MD, set the REC OUT

SELECTOR switch

u to “TAPE-1 1 2”.

To copy from TAPE-2/MD to TAPE-1/CD-R, set the REC OUT

SELECTOR switch

u to “TAPE-2 1 1”.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

Comments to this Manuals

No comments