Denon AVR-1912 Owner's Manual download pdf (Page 59)

Set up the

remote control unit

n Set up the zone mode

Press ZONE SELECT to switch the zone mode to

J (MAIN ZONE).

The J indicator lights.

Press ZONE SELECT

n Set up the operation mode

Press AMP to set the remote control unit to AMP-

operation mode.

Press AMP

Connect the setup microphone.

MultEQ XT

Preparation

Connect the speakers and place then according

to the recommendations in the manual.

Audyssey Auto Setup

[RETURN][ENTER] Enter Cancel

When the setup microphone is

connected, the following screen is

displayed.

Select “Next”, and then press

ENTER.

Set up speakers

around items indicate the settings.

This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).

For the setup methods of the 7.1-channel system with surround back speakers, see C page 4 “Setup Wizard”.

First install and connect the speakers to this unit.

Before Auto Setup measurement, the settings shown below can be made.

•Changing the ampliﬁer assignment (Amp Assign)

The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage56 “Set up “Amp Assign””).

•Setting the channels to be used (Channel Select)

If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage57

“Set up “Channel Select””).

Set up “Amp Assign”

Use ui to select “Amp Assign”, and then press

ENTER.

MultEQ XT

Amp Assign NORMAL

Amp Assign

[RETURN] Return

MultEQ XT

Preparation

Set the following items

if necessary.