Denon AVR-5805CI User Manual download pdf (Page 95)

Advanced Operation

Select the ZONE2 mode using the AMP

button.

Adjustment steps that need to be performed

prior to surround sound playback in ZONE2

2 Test Tone

• Before playing with the surround function, be sure to use

the test tones to adjust the playback level from the

different speakers. This adjustment can be performed with

the system setup ( page 122, 123) or from the remote

control unit, as described below.

• Adjusting with the remote control unit using the test tones

is only possible in the “Auto” mode and only effective in

the STANDARD (DOLBY/DTS SURROUND) modes. The

adjusted levels for the different modes are automatically

stored in the memory.

Select the ZONE2 mode using the AMP

button.

Press the CH SEL/ENTER button.

• The “Channel Vol.” screen appears.

2 Channel Level

• After adjusting using the test tones, adjust the channel

levels either according to the playback sources or to suit

your tastes, as described below.

Press the CURSOR

or CH SEL/ENTER

button to select the speaker.

The channel switches as shown below each time the

CH SEL/ENTER button is pressed.

Press the CURSOR

button to adjust the

level.

The adjustment range for the different channels is

+12.0 dB to –12.0 dB.

The sound from the subwoofer can be completely cut

by lowering the SW (subwoofer) setting one additional

step from –12.0 dB (setting it to “OFF”).

FADER

SBL

SBR

ZONE2 surround back speakers are only displayed when

“7.1ch” is selected for the ZONE2 channel output

setting at “Channel Setup” ( page 126 ~ 128).

When the ZONE2 surround back speaker setting is set

to “1spkr” for “Speaker Configuration”, this is set to

“SB”.

• For instructions on making the settings ( page 120 ~ 125).

Select the ZONE2 mode using the AMP

button.

Press the SYSTEM SETUP button.

• The ZONE2 system setup menu appears.

The screen displayed depends on the settings made at

“Channel Setup” ( page 126 ~ 128).

System setup for multi-zone

• This makes possible to make the optimum setting for the

speaker systems used in ZONE2.

Press the CURSOR

button to adjust all

the speakers to the same volume.

After completing the adjustment, press the

TEST TONE button again.

Example: When “ZONE2” is set for a 5.1 or 7.1 channel

system

Example: When “ZONE2” is set for a STEREO or MONO

Press the TEST TONE button.

• The “Test Tone” screen appears.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 213 214

Comments to this Manuals

No comments

Denon AVR-5805CI User Manual Page 95

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-5805CI