Denon MULTEQXT AVR-4306 Operations Instructions download pdf (Page 31)

Basic Operation Basic Operation

Turning the sound off temporarily (MUTING)

Use this to mute the audio output temporarily.

2 Operate the video select from the main unit

2 Operate the video select from the remote

control unit

Press the MUTING button.

•You can adjust the muting level ( page 77).

• Cancelling MUTING mode:

Press the MUTING button again, or press the VOLUME button on

the remote control, or adjust the volume up or down via the

front panel VOLUME knob.

Connect the headphones to the PHONES jack.

• The pre-out output (including the speaker output) is

automatically turned off when headphones are connected.

NOTE:

•To prevent hearing loss, be careful not to raise the volume

level excessively when using headphones.

Listening over headphones

Press the VIDEO SELECT button until the desired

image appears.

Press the VIDEO SELECT button, turn the FUNCTION

knob until the desired image appears on the display.

Combining the currently playing sound with

the desired image (VIDEO SELECT)

• Cancelling simulcast playback:

Select “SOURCE” pressing the VIDEO SELECT button.

• It is not possible to select HDMI input signals.

• When playing HDMI video input signals, the analog video signal

of another function cannot be selected for the HDMI video

output.

(Main unit)

The video source selected with the video select function is

stored in the memory for the different input sources.

VIDEO SOURCE

DVD

Switching the surround speakers

Press the SPEAKER button.

The surround speakers switch as shown below each time

the SPEAKER button is pressed.

SURROUND A

SURROUND A+B

SURROUND B

This operation is possible when the setting for using both

surround speakers A and B is made at “Setting the type of

speakers” ( page 82).

•When using the pre-out terminals, set to either “A” or “B”.

Playback using the external input (EXT. IN)

terminals

Press the EXT. IN button on the main unit or INPUT

MODE

button on the remote control unit to switch

the external input.

When operating the remote control unit:

NOTE:

• When the input mode is set to the external input (EXT. IN),

the surround mode (DIRECT, STEREO, STANDARD, 7CH

STEREO, WIDE SCREEN or DSP SIMULATION) cannot be

set.

• In play modes other than the external input mode, the

signals connected to these terminals cannot be played. In

addition, signals cannot be output from channels not

connected to the input terminals.

• Cancelling the external input mode:

Press the INPUT MODE or ANALOG button to switch to the

desired input mode ( page 27, 28).

• The external input mode can be set for any input source. To

watch video while listening to sound, select the input source to

which the video signal is connected, then set this mode.

• If the subwoofer output level seems too high, set the “SW

ATT” surround parameter to “ON”.

AUTO

EXT.IN ANALOG

PCM DTS

The mode switches as shown below each time the INPUT

MODE button is pressed:

(Remote control unit)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 145 146

Comments to this Manuals

No comments

Denon MULTEQXT AVR-4306 Operations Instructions Page 31

Comments to this Manuals

Related products and manuals for AV receivers Denon MULTEQXT AVR-4306