Denon MULTEQXT AVR-4306 Operations Instructions download pdf (Page 69)

Advanced OperationAdvanced Operation

Switch off the unit using the main unit’s POWER

switch.

Hold the following ROOM EQ button and NIGHT

button, and turn the main unit’s POWER switch

on.

• If step 3 does not work, start over from step 1.

• If the microprocessor has been reset, all the settings are reset

to the default values (the values set upon shipment from the

factory).

Last function memory

• This unit is equipped with a last function memory which stores

the input and output setting conditions as they were

immediately before the power is switched off.

This function eliminates the need to perform complicated

resetting when the power is switched on.

• The unit is also equipped with a back-up memory. This function

provides approximately one week of memory storage from

when the main unit’s power switch is off and with the power

supply cord disconnected.

Initialization of the microprocessor

• In very rare instances, the AVR-4306 internal microprocessor

might lock up, or otherwise cause mis-operation. This might be

caused due to an AC line surge or line spike noise, or by static

electric discharge on or nearby the unit, or to connected

components. If the condition cannot be corrected by powering

off the unit, including disconnection of the power supply cord

for a period of ten minutes and subsequent re-connection, then

the unit may have to be re-initialized. Doing so will restore the

microprocessor to its original out-of-the-box state, with all

custom memories and settings erased, and the original factory

default settings restored. Only use this procedure if you are

sure that the microprocessor requires re-initialization.

Check that the entire display is flashing with an

interval of about 1 second, and release your

fingers from the 2 buttons.

• The microprocessor will be initialized.

Multi-source recording / playback

2 Playing one source while recording another

(REC OUT mode)

Press the ZONE2/3/REC SELECT button until

“ZONE2 SOURCE” appears on the display.

With “ZONE2 SOURCE” displayed, turn the

FUNCTION knob until “RECOUT SOURCE”

appears on the display.

• The REC indicator lights.

With “RECOUT SOURCE” displayed, turn the

FUNCTION knob to select the source you wish to

record.

Set the recording mode.

For operating instructions, refer to the manual of the

component on which you want to record.

RECOUT SOURCE

DVD

•To cancel, turn the FUNCTION knob and select “SOURCE”.

• Recording sources other than digital inputs selected in the REC

OUT mode are also output from the ZONE2 preout terminals.

• If and only if the digital signal being input from the digital input

terminal (optical/coaxial) is a PCM signal, it is output from the

analog REC OUT terminals.

• When “DENON LINK” is assigned at “Digital In Assign”, it is

not possible to output the PCM signal and Network Audio

signals (Internet radio music server, USB) being input from the

digital audio input terminal from the analog REC OUT terminals

( page 67).

• When the REC OUT mode is selected, the ZONE2 button on the

remote control unit cannot be operated.

• Network Audio (Internet radio, music server or USB) signals are

not output from the OPTICAL 3 OUT and OPTICAL 4 OUT

terminals.

The function switches as shown below when the FUNCTION

knob is turned.

ZONE2 SOURCE ZONE2 TUNER

····

ZONE2 V.AUX

RECOUT SOURCERECOUT VCR-2RECOUT V.AUX

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 145 146

Comments to this Manuals

No comments

Denon MULTEQXT AVR-4306 Operations Instructions Page 69

Comments to this Manuals

Related products and manuals for AV receivers Denon MULTEQXT AVR-4306