Denon MULTEQXT AVR-4306 Operations Instructions download pdf (Page 89)

Advanced Setup – Part 2 Advanced Setup – Part 2

Press the CURSOR

button to set the

distance between the center speaker and

listening position.

Example: When the distance is set to 10 feet for the

center speaker

The distance changes in units of 1 foot (0.1 meters) or 0.1

foot (0.01 meters) each time the button is pressed. Select

the value closest to the measured distance.

When “Step” is selected, you can select the unit of “1 ft

(0.1 m)” or “0.1 ft (0.01 m)”.

When “Yes” is selected for “Default”, the settings are

automatically reset to the default values.

Please note that the difference of distance for every

speaker should be 20 ft (6.0 m) or less. If you set an

invalid distance, a CAUTION notice, such as screen right

will appear. In this case, please relocate the blinking

speaker(s) so that its distance is no larger than the value

shown in highlighted line.

The “Surr. Sp.” can only be selected when both surround

speakers A and B have been selected at the System Setup

Menu (when both A and B have been set to “Large” or

“Small”).

When the surround back speaker setting is set to “1spkr”

for “Speaker Configuration”, this is set to “SB”.

Press the ENTER button to enter the setting.

• The “Speaker Setup” menu reappears.

• Use this setting to adjust so that the playback level between

the different channels is equal.

•From the listening position, listen to the test tones produced

from the speakers to adjust the level.

Press the CURSOR

button to select

“Channel Level” at the “Speaker Setup” menu,

then press the ENTER button.

• The “Channel Level” screen appears.

Press the CURSOR

button to select “Test

Tone Start”, then press the CURSOR

button to

select “Yes”.

Press the CURSOR

button to select

“Auto” or “Manual”.

-1

When “Auto” mode is selected:

Press the CURSOR

button to adjust all

the speakers to the same volume.

• The test tones are emitted from each speaker in the

following order, at 4-second intervals during the first and

second time, and at the 2-second intervals during the

third and subsequent cycles:

Auto:

Adjust the level while listening to the test tones produced

automatically from each speaker.

Test tones are automatically emitted from each speaker.

Manual:

Select the speaker from which you want to produce the test

tone to adjust the level.

Surr. Sp. : A

Adjusts the balance of the playback level between the

channels when using surround speaker A.

Surr. Sp. : A + B

Adjusts the balance of the playback level between the

channels when using surround speakers A and B at the same

time.

Surr. Sp. : B

Adjusts the balance of the playback level between the

channels when using surround speaker B.

Press the CURSOR

button to select “Surr.

Sp.”, then press the CURSOR

button to

select the surround speaker(s) from which you

want to produce the test tone (A, B or A+B).

Example: When the “Auto” mode is selected

1spkr

2spkrs

SBL

SBR

Setting the Channel Level

The AVR-4306 automatically sets the optimum surround

delay time for the listening room.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 145 146

Comments to this Manuals

No comments

Denon MULTEQXT AVR-4306 Operations Instructions Page 89

Comments to this Manuals

Related products and manuals for AV receivers Denon MULTEQXT AVR-4306