Denon AVR-786 User Manual download pdf (Page 47)

ENGLISH

Advanced Setup – Part 1

The system setup settings can be locked so that they cannot be

changed easily.

Setting the Setup Lock

Press the CURSOR

button to select

“Setup Lock” at the “Option Setup” menu, then

press the ENTER button.

• The “Setup Lock” screen appears.

Press the CURSOR

button to select “ON”, to

lock the system setup settings.

Press the ENTER button to finalize the setting

and exit the system setup mode.

• When the setup lock function is activated, the settings listed

below cannot be changed, and “SETUP LOCKED” is displayed

when related buttons are operated.

• System setup settings

• Surround parameter settings

• Tone control settings

• Channel level settings (including test tones)

• To unlock, press the SETUP button again and display the “Setup

Lock” screen, then select “OFF” and press the ENTER button.

• System setup is complete. Once these settings are made,

there is no need to change them unless different AV components

are connected or the speakers are repositioned.

This Speaker Setup section describes the procedures to make

speaker settings manually (without using the Auto Setup

function), as well as to make manual changes to settings that

have already been made by the Auto Setup function.

Advanced Setup – Part 2

Press the CURSOR

button to select

“Speaker Setup” at the “System Setup” menu,

then press the ENTER button.

• The “Speaker Setup” screen appears.

Setting the Speaker Config.

Speaker Setup

The composition of the signals output to each channel and the

frequency response are adjusted automatically according to the

combination of speakers actually being used.

Press the CURSOR

button to select

“Speaker Config.”, then press the ENTER button.

• The “Speaker Config.” screen appears.

Press the CURSOR

button to select a

speaker, then press the CURSOR

button

to select a parameter.

Center Sp.

Front Sp.

Subwoofer

Surround Sp.

Surround back Sp.

Press the ENTER button to enter the setting.

• The “Speaker Setup” menu appears.

• Select “Large” or “Small” not according to the actual size of

the speaker but according to the speaker’s capacity for playing

low frequency (bass sound below the frequency set for the

Crossover Frequency) signals. If you are unsure, try comparing

the sound at both settings (setting the volume to a level low

enough so as not to damage the speakers) to determine the

proper setting.

ENTER

CURSOR

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 67 68

Comments to this Manuals

No comments

Denon AVR-786 User Manual Page 47

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-786