Denon AVR-4306 User Manual download pdf (Page 87)

Advanced Setup – Part 2

This Speaker Setup section describes the procedures to make speaker settings manually (without using the Auto Setup function), as

well as to make manual changes to settings that have already been made by the Auto Setup function.

• If the “Auto Setup” procedure has already been performed, there is no need to make this setting.

• Perform this setting if you wish to make the settings for your speaker systems manually.

Speaker Setup

Press the ENTER button to enter the setting.

• The “Speaker Setup” menu reappears.

ENTER

CURSORSYSTEM SETUP

Setting the type of speakers

The composition of the signals output to each channels and the

frequency response are adjusted according to the combination of

speakers actually being used.

Press the CURSOR

button to select

“Speaker Setup” at the “System Setup Menu”,

then press the ENTER button.

• The “Speaker Setup” menu screen appears.

Press the CURSOR

button to select

“Speaker Config.”, then press the ENTER button.

• The “Speaker Config.” screen appears.

Center Sp.

Front Sp.

Subwoofer

Surround Sp. A

Surround back Sp.

Surround Sp. B

Press the CURSOR

button to select the

speaker, then press the CURSOR

button

to select the parameter.

• Select “Large” or “Small” not according to the actual size of

the speaker but according to the speaker’s capacity for playing

low frequency (bass sound below the frequency set for the

Crossover Frequency) signals. If you do not know, try

comparing the sound at both settings (setting the volume to a

level low enough so as not to damage the speakers) to

determine the proper setting.

2 Parameters

Large:

Select this when using speakers that can fully reproduce deep

bass well below the frequency set for the Crossover Frequency

mode.

Small:

Select this when using speakers that are not capable of

handling deep bass well below the frequency set for the

Crossover Frequency mode. Deep bass content in any channel

with a SMALL speaker is routed to the subwoofer(s).

Yes / No:

Select “Yes” when a subwoofer is installed, “No” when a

subwoofer is not installed.

None:

Select this when no speakers are installed.

2spkrs / 1spkr:

Select the number of speakers to be used for the surround back

channel.

ENTER

CURSOR

SYSTEM SETUP

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 145 146

Comments to this Manuals

No comments

Denon AVR-4306 User Manual Page 87

Comments to this Manuals

Related products and manuals for Acoustics Denon AVR-4306