Denon AVR-1906 User Manual download pdf (Page 5)

ENGLISH

Getting Started Getting Started

Accessories

Check that the following parts are included in addition to the main unit:

q Operating instructions ............................1

w Warranty .................................................1

e Service station list ..................................1

r Remote control unit (RC-978) .................1

ty iu

t R6P/AA batteries ....................................2

y AM loop antenna ....................................1

u FM indoor antenna .................................1

i Omnidirectional microphone...................1

Before using

Pay attention to the following before using this

unit:

• Moving the unit

To prevent short-circuits or damaged wires in

the connection cables, always unplug the power

supply cord and disconnect the connection

cables between all other audio components

when moving the unit.

• Before turning the power switch on

Check once again that all connections are

correct and that there are not problems with

the connection cables. Always set the power

switch to the standby position before

connecting and disconnecting connection

cables.

• Store these instructions in a safe place.

After reading, store this instructions along with

the warranty card in a safe place.

• Note that the illustrations in these

instructions may differ from the actual unit

for explanation purposes.

•V. AUX terminals

The AVR-1906’s front panel is equipped with

V. AUX terminals. Remove the cap covering

the terminals when you want to use them.

Cautions on installation

Noise or disturbance of the picture may be

generated if this unit or any other electronic

equipment using microprocessors is used near

a tuner or TV.

If this happens, take the following steps:

• Install this unit as far away as possible

from the tuner or TV.

• Run the antenna wires from the tuner or

TV away from this unit’s power supply cord

and input/output connection cables.

• Noise or disturbance tends to occur

particularly when using indoor antennas or

300 Ω/ohm feeder wires. We recommend

using outdoor antennas and 75 Ω/ohm

coaxial cables.

Wall

Note

Cautions on handling

• Switching the input source when input terminals are not connected.

A clicking noise may be produced if the input source is switched when nothing is connected to

the input terminals. If this happens, either turn down the MASTER VOLUME control knob or

connect components to the input terminals.

•Muting of PRE OUT terminals, PHONES jack and SPEAKER terminals.

The PRE OUT terminals, PHONES jack and SPEAKER terminals include a muting circuit. Because

of this, the output signals are greatly attenuated for several seconds after the power switch is

turned on or the input source, surround mode or any other set-up is changed. If the volume is

turned up during this time, the output will be very high after the muting circuit stops functioning.

Always wait until the muting circuit turns off before adjusting the volume.

•Whenever the power switch is in the STANDBY state, the unit is still connected to AC line

voltage.

Please be sure to turn off the power switch or unplug the cord when you leave home for,

say, a vacation.

Preparing the remote control unit

The included remote control unit (RC-978) can be used to operate not only the AVR-1906 but other

remote control compatible DENON components as well. In addition, the memory contains control

signals for other remote control units, so it can be used to operate non-DENON remote control

compatible products.

Note:

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar

enclosure.

1 2 3 4 5 6 7 8 9 10 ... 66 67

Comments to this Manuals

No comments

Denon AVR-1906 User Manual Page 5

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-1906