Denon AVR 588 - AV Receiver Operations Instructions download pdf (Page 20)

l The composition of the signals output from the different channels and the frequency response are adjusted automatically according to the

combination of speakers actually being used.

Press “CURSOR/PAGE” at the center of the bottom line on the “AV AMP’s” “SETTING 3/5” page so

that this part is displayed in half-tone dot mesh.

Make the system setups by pushing the jog suck on the remote control unit forward and backward, left

and right.

At the System Setup Menu select “Speaker Configuration”

lwnmln

Switch to the speaker configuration screen

Set whether or not speakers are

connected and, if so, their size

parameters.

l To select the speaker

l To select the parameter

center sp.

Speaker Configuration

&rround

Subwoofer

Surround Sp. A

Surrowd back Sp

Surround Sp. B ,

Enter the setting.

a) If no surround speakers are used (if “None” is set for both A and 6):

The Crossover Frequency screen appears.

b) If both surround speakers A and B are used (if either “Large” or “Small” is set for both A and B):

The surround speaker setting screen appears.

c) When “Front” is set to “Large” and “Subwoofer” is set to “Yes”,

the set switches to the subwoofer mode

d) If “None” is set for surround speakers A:

“None” is automatically set for surround speakers B and surround back speaker.

NOTE:

l Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency

(bass sound below frequency set for the Crossover Frequency mode and below) signals. If you do not know, try comparing the sound at both

settings (setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 137 138

No comments

Denon AVR 588 - AV Receiver Operations Instructions Page 20