20
ENGLISH
Checking the currently playing program source, etc.
When an operation is performed on the remote control unit, that operation appears on the display, making it possible to check the operation
visually.
The set’s operating status can also be checked on the display using the procedure described below.
1
Front panel display
• Descriptions of the unit’s operations are also displayed on
the front panel display. In addition, the display can be
switched to check the unit’s operating status while playing a
source by pressing the STATUS button.
DVD / VDP
VCRV. AUXPHONOTUNER
CD
CDR / TAPE
PHONO
DVD / VDP
CD VCR
PRESET
SPEAKER
AB
CDR / TAPE
V. AUXTUNER
DIMMER CH VOL
STATUS
VIDEO SELECT
SHIFT
MUTING
MASTER VOL
PRESET
REMOTE CONTROL UNIT RC-894
B
•
ª
•
ª
•
ª
•
ª
1
2
1
Follow steps 1 to 3 under “Playing the program source”
(page 14).
Recording the program source
(recording the source currently being monitored)
2
Start recording on the tape or video deck.
For instructions, refer to the component’s operating
instructions.
The signals of the source selected with the function selector button are output simultaneously to the CDR/TAPE and VCR REC OUT jacks.
If a total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded simultaneously
on every decks.
Simultaneous recording
(Remote control unit)
2
Using the dimmer function
• Use this to change the brightness of the display.
The display brightness changes in four steps (bright,
medium, dim and off) by pressing the main unit’s DIMMER
button repeatedly.
(Remote control unit)
The brightness changes in 3 steps each time the button is
pressed, and finally the display turns off.
Comments to this Manuals