Denon CEOL Piccolo Owner's Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 65
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
17
Setting the network [Network]
5
If there is an encryption setting for the access point
you selected in step 4, enter same encryption key as
used for the access point. (If there is no encryption
setting, proceed to step 6.)
Use uio p or 0 – 9, +10 to input the “Password” (encryption
key) and press ENTER or p. Enter the same encryption key as
used for the access point.
•The types of characters that can be input are as shown below.
GLower case charactersH
abcdefghijklmnopqrstuvwxyz
GUpper case charactersH
ABCDEFGHIJKLMNOPQRSTUVWXYZ
GSymbolsH ! “ # $ % & ‘ ( ) z + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜
GNumbersH
0123456789 (Space)
•When no security settings have been used in the Internet
connection settings, this step is not necessary.
6
Use i to select “Test Connection”, then press ENTER
or p.
“Wait for the network to connect...” is displayed, and the unit
starts connecting to the network.
•This unit performs automatic network setup due to the DHCP
function.
n WPS Settings (Push-button method)
By just pressing the WPS button on your router and this unit, the
wireless LAN connection settings are made.
•Before turning this unit on, make sure that an Ethernet cable is
not connected to this unit. If a cable is connected, have this unit
enter the power standby mode and disconnect the cable.
•After the unit is turned on, it takes approximately 30 seconds for
the WPS button on this unit to be available.
1
Press the WPS button of the router.
2
Press WPS on the rear panel.
“Wait for the network to connect...” is displayed, and the unit
starts connecting to the LAN.
•When connection is established with access point, “Connected!”
is displayed.
•If the connection cannot be established, “Connection Failed” is
displayed. Perform steps 1 – 2 again.
NOTE
If the router uses WEP, WPA-TKIP or WPA2-TKIP encryption,
connection is not possible using the WPS button. In this case, connect
using “Auto-scan” or “Manual”.
Connecting wireless LAN
Use this procedure to configure the wireless LAN settings.
n Auto-Scan (Wireless LAN)
If a LAN cable is connected, remove it.
1
Press POWER X to turn on
power to the main unit.
2
Press SETUP.
Turns on the menu settings mode
and the menu appears on the display
(vpage9 “Menu map”).
3
Use ui and ENTER to select
“Network” – “Settings” – “Auto-
Scan”, then press ENTER or p.
The access point you have set is
displayed.
4
Use ui to select the access
point, and then press ENTER or
p.
•If the access point is not detected
automatically, configure it manually
(vpage18 “Manual Settings”).
Preparations
Operations
Information
Preparations
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 64 65

Comments to this Manuals

No comments