Denon AVR-3600 User Manual download pdf (Page 21)

7“4 Remote control unit learning function

If your AV components are not Denon products or if operation is not possible with the preset memory settings, the components' remote control signals

can be "learned" to enable remote control operation.

The buttons that can be "learned" are the CD, DAT and DECK system buttons (see page 18) and the VDP, VCR and TV system buttons (see page

20), (For the TV only, the A block buttons can also be "learned",)

Press the USE/LEARN selector button with the tip of a

pen etc,, to set the learn mode. Both the START and

LEARNED/TX indicators flash.

2, Set the program switch to the side to be "learned".

Set to the AUDIO side for the CD, tape deck or DAT posi

tion, to the VIDEO side for the VDP, VCR or TV position.

AUDIO

AVRTAVC VIDEO

3. Set the program switch to the position to be "learned",

CD DECK DAT

VDP VCR TV

4, Set the remote control units so they are facing each oth

er, then press the button to be "learned" on this unit's

remote control unit.

Transmitting windoxA's

Lit

This unit's remote

control unit

The indicator stops flashing and the START LED lights.

The learnable buttons are the buttons which can be op

erated with the DENON system codes for the CD player,

DAT and tape deck, the buttons which can be operated

with the preset memory for the VCR, VDP and TV. For

the TV only, however, the buttons in the section indi

cated "A" on the diagram above can also be "learned".

Use these to "learn" TV channels.

NOTE:

® Use button (tl)/ 0 as the 0 number button, button

@ / E as the enter button.

Check that the START LED is lit, then press the button

to be "learned" on the other remote control unit.

6, Once the START LED turns off and the LEARNED/TX

LED lights, release the button on the other remote con

trol unit.

The two LEDs start flashing again.

7, To "learn" other buttons, repeat steps 2 to 6,

8. Once the learning operation is completed, press the

USE/LEARN selector button again.

The two LEDs stop flashing and the learning mode is

cancelled.

Check that the stored codes work properly.

NOTES:

Up to 26 codes can be "learned", but this number may be lower if the codes are long.

If a non-learnable button is pressed or two or more buttons are pressed at once, the two LEDs will once again light when the button(s) is

released,

if the codes could not be stored, the LEARNED/TX LED does not light after the START LED turns off. For limited number of models, codes

cannot be stored in RC-820.

If the two LEDs start flashing rapidly after the START LED lights, this means that the memory is already full, and the code you have just

attempted to store was not stored.

To "learn" that code, first perform the resetting operation.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Comments to this Manuals

No comments

Denon AVR-3600 User Manual Page 21

Comments to this Manuals