Denon AVR 4806 - AV Receiver Operations Instructions Page 45

  • Download
  • Add to my manuals
  • Print
  • Page
    / 154
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 44
45
Basic Operation
Press the ON SCREEN button.
Each time an operation is performed, a description of
that operation appears on the display connected to AVR-
4806’s VIDEO MONITOR OUT terminal. Also, the unit’s
operating status can be checked during playback.
Such information as the position of the input selector
and the surround settings is output in sequence.
Checking the currently playing program
source, etc.
2 On screen display
Input mode
The AVR-4806 has an AUTO signal detection mode that
automatically identifies the type of incoming audio signals,
but is also equipped with a manual mode that can be
switched according to the type of input audio signals.
Press the INPUT MODE button.
The mode switches as shown below each time the
INPUT MODE button is pressed.
2 Selecting the AUTO, PCM and DTS modes
AUTO PCM DTS
AUTO (All auto mode):
In this mode, the types of signals being input to the
digital and analog input terminals for the selected input
source are detected and the program in the AVR-4806’s
surround decoder is selected automatically upon
playback. This mode can be selected for all input
sources other than PHONO and TUNER.
The presence or absence of digital signals is detected,
the signals input to the digital input terminals are
identified and decoding and playback are performed
automatically in DTS, Dolby Digital or PCM (2 channel
stereo) format. If no digital signal is being input, the
analog input terminals are selected.
Use this mode to play Dolby Digital signals.
Switching the surround speakers
Press the SPEAKER button.
The surround speakers switch as shown below each
time the SPEAKER button is pressed.
SURROUND A
SURROUND A+B
SURROUND B
This operation is possible when the setting for using
both surround speakers A and B is made at “Speaker
Configuration” ( page 113, 114).
Press the DIMMER button.
The display brightness changes in four steps (bright,
medium, dim and off).
2 Using the dimmer function
Use this to change the brightness of the display.
Press the STATUS button.
Descriptions of the unit’s operations are also displayed
on the front panel display. In addition, the display can be
switched to check the unit’s operating status while
playing a source.
2 Front panel display
DTS (exclusive DTS signal playback mode):
Decoding and playback are only performed when DTS
signals are being input.
PCM (exclusive PCM signal playback mode):
Decoding and playback are only performed when PCM
signals are being input.
Note that noise may be generated when using this
mode to play signals other than PCM signals.
Page view 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 153 154

Comments to this Manuals

No comments