Denon AVR-1306 User Manual download pdf (Page 8)

ENGLISH

Easy OperationEasy Operation

Speaker connections

• Connect the speaker terminals with the

speakers making sure that like polarities are

matched (

with

). Mismatching

of polarities will result in weak central sound,

unclear orientation of the various instruments,

and the stereo image being impaired.

• When making connections, take care that

none of the individual conductors of the speaker

cable come in contact with adjacent terminals,

with other speaker cable conductors, or with

the rear panel.

2 Speaker impedance

• When speaker systems A and B are used

separately, speakers with an impedance of 6

to 16 Ω/ohms can be connected for use as

front speakers.

•Be careful when using two pairs of front

speakers (A + B) at the same time, since

speakers with an impedance of 12 to 16

Ω/ohms in this case must be used.

• Speakers with an impedance of 6 to 16

Ω/ohms can be connected for use as center

and surround speakers.

•The protector circuit may be activated if the

unit is operated for long periods of time at

high volumes when speakers with an

impedance lower than the specified

impedance are connected.

Protector circuit

This unit is equipped with a high-speed

protection circuit. The purpose of this circuit

is to protect the speakers under circumstances

such as when the output of the power

amplifier is inadvertently short-circuited and

a large current flows, when the temperature

surrounding the unit becomes unusually

high, or when the unit is used at high output

over a long period which results in an

extreme temperature rise.

When the protection circuit is activated, the

speaker output is cut off and the power

supply indicator flashes. Should this occur,

please follow these steps: be sure to switch

off the power of this unit, check whether

there are any faults with the wiring of the

speaker cables or input cables, and wait for

the unit to cool down if it is very hot.

Improve the ventilation condition around the

unit and switch the power back on.

If the protection circuit is activated again

even though there are no problems with the

wiring or the ventilation around the unit,

switch off the power and contact a DENON

service center.

Note on speaker impedance

The protector circuit may be activated if the

unit is operated for long periods of time at

high volumes when speakers with an

impedance lower than the specified

impedance (for example speakers with an

impedance of less than 4 Ω/ohms) are

connected. If the protector circuit is

activated, the speaker output is cut off. Turn

off the unit’s power, wait for the unit to cool

down, improve the ventilation around the

unit, then turn the power back on.

NOTE:

NEVER touch the speaker terminals

when the power is on. Doing so could

result in electric shocks.

Connecting the speaker cables

1. Loosen by turning

counterclockwise.

2. Insert the cable.

3. Tighten by turning

clockwise.

><<>><<>

><><

(

) (

)

(

) (

)

2 Connections

When making connections, also refer to the operating instructions of the other components.

Connection terminal

for a subwoofer with

built-in amplifier.

Surround speaker

systems

Subwoofer

Front speaker

systems (B)

Precautions when connecting speakers:

If a speaker is placed near a TV or video monitor, the colors on the screen may be disturbed by

the speaker’s magnetism. If this should happen, move the speaker away to a position where it

does not cause this effect.

Front speaker

systems (A)

Center

speaker

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 90 91

Comments to this Manuals

No comments

Denon AVR-1306 User Manual Page 8

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-1306