Denon AVR-887 User Manual download pdf (Page 66)

ENGLISH

Advanced Setup – Part 2Advanced Setup – Part 2

• The crossover frequency mode is valid only when subwoofer is set

to “ON”, and when one or more speakers are set to “Small”, as

described in section “Setting the Speaker Configuration” ( page

60).

• If “LFE+Main” is set at “Subwoofer Setup”, “SW:LFE+Main” (

page 61) is displayed at the top right of the screen.

• Set to “80 Hz” when using regular speakers. When using small

speakers, we recommend setting to a higher frequency.

Others Setup

Setting the Room Equalizer Setup

Set the Room Equalizer setting with “All” or “Assign” for each

surround mode.

Press

FF GG

to set, then press ENTER.

All:

Sets the equalizer for all surround modes.

Assign:

Sets the equalizer individually for each surround mode ( page

28).

When “All” is selected:

Press

FF GG

to set.

OFF:

The equalizer is not used.

Normal:

Adjust the frequency response of all speaker suitable for general

surround system.

Front:

Adjusts the frequency response of the surround speakers to match

the characteristics of the front channel speakers.

Flat:

Adjusts the frequency response of all speakers to the flattest

response. This mode is suitable for multi-channel music surround

sound sources.

Manual:

Selects the setting value that was set in the “Setting the Manual

Equalizer Setup” ( page 57).

Press

DD HH

to select “Room EQ Setup”, then press

ENTER.

Press ENTER.

Setting the Crossover Frequency

Set the frequency (Hz) below which the bass sound of the various

speakers is to be output from the subwoofer.

For speakers that are set to “Small”, frequencies under the crossover

frequency are cut before the signal is output, and the low frequency

component that was cut is output from the subwoofer or the

speakers that are set to “Large”.

Press

DD HH

to select “Crossover Frequency”, then

press ENTER.

Press

FF GG

to set.

40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:

Set as desired according to your speakers’ bass playback ability.

Press ENTER.

• The equalizer setting of “Normal”, “Front” and “Flat” can be

selected after performing the Auto Setup.

• When the speaker set as “None” with the Auto Setup is changed to

on manually, the equalizer of “Normal”, “Front” and “Flat” cannot

be used.

• When headphones are connected, the Room Equalizer cannot be

used.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 81 82

Comments to this Manuals

No comments

Denon AVR-887 User Manual Page 66

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-887