Denon DRA-F101 User Manual download pdf (Page 14)

ENGLISH

(2) Presetting AM and FM stations

Example: To preset the currently tuned in FM station at preset number “3”

Procedure

Press the MEMORY/SET button.

• The “P.SET”, “MEMO”

indicator flashes.

• Depending on what preset number is

displayed before the button is pressed, the

preset number section flashes as shown

below and the setting standby mode is set.

When “01” to “10” or “0-” is displayed,

“0-” flashes.

When “11” to “20” or “1-” is displayed,

“1-” flashes.

When “21” to “30” or “2-” is displayed,

“2-” flashes.

When “31” to “40” or “3-” is displayed,

“3-” flashes.

✽

To store the station at a different preset

number, use the tuning buttons (TUNING UP

or DOWN) to set the desired preset number.

Press the MEMORY/SET button

again while the “MEMO”

indicator is flashing.

• The “MEMO” indicator turns

off and the station is preset.

✽

A total of 40 AM and FM stations can be preset

using this procedure.

Presetting

• When a station is preset, both the reception

frequency and reception mode are stored in the

memory.

• If a station is preset at a number where another

station is already preset, the previous station is

erased and the new station is set.

• The preset memory is not erased immediately if the

power supply is cut off momentarily.

• This setting can also be made by pressing the

button instead of pressing “e”.

• To store the station at a different preset number,

use the number buttons and the +10 button on the

system remote control unit (RC-927) to set the

desired preset number.

Examples:

To store the station at preset number 12:

Press ,

To store the station at preset number 29:

Press , ,

+10

TUNING

PHONES

SYSTEM

VOLUME

ON / STANDBY

AM-FM STEREO RECEIVER DRA-F101

SOURCE

DIRECT

BANDUPDOWN

TUNING

MEMORY

/ SET

FUNCTION

TIMERTONE DISPLAY

1, 3 2

UPDOWN

TUNING

MEMORY

/ SET

MEMORY

/ SET

MEMORY

/ SET

MEMORY

/ SET

DRA-F101

(this unit)

DRA-F101

(this unit)

(RC-927)

✽

When operating with the

system remote control unit,

first set the remote control

unit’s function selector switch

to “TUNER”.

TUNER

TAPE

(RC-927)

(3) Tuning in Preset Stations

Example: To tune in the station stored at preset

number “3”

✽

When operating with the

system remote control unit,

first set the remote control

unit’s function selector switch

to “TUNER”.

TUNER

TAPE

(RC-927)

Procedure:

• Instead of pressing e, the preset

channel can also be called out by

pressing the < or > button to display

“P.SET 03”.

• To call the station at a different preset number, use

the number buttons and the +10 button on the

system remote control unit (RC-927) to set the

desired preset number.

Examples:

To call the station at preset number 12:

Press ,

To call the station at preset number 29:

Press , ,

+10

While the “MEMO” indicator

is flashing, press the TUNING

UP button three times to

display “P.SET”, “03”.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 36 37

Comments to this Manuals

No comments

Denon DRA-F101 User Manual Page 14

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon DRA-F101